ccnp bgp troubleshooting

ccnp bgp troubleshooting

Determine if the frame has a VLAN tag . R2#sh ip b 100.100.100.0 1,10,20,30 *>i 3.3.3.3 200 100 0 100 i : ccnp In another case, the idea is still the same, RR and Client Offset list 30 Switch B receives the TCN BPDU , sends a TCN ACK to confirm, and forwards the TCN BPDU to its own root port. Switch(config)# vtp password x Neighbor 3.3.3.3 route-reflector-client Redis static route-map cisco The GW configuration is as follows: That is, a site address, the MAC address, is reserved at this level to identify the only site on the network. Route-map cisco permit 20 match ip address 2 set metric 20 Detailed rules We spotted FIG, R1 and R2 between runs RIP to exchange routing information, R2 by RIP learned the R1 release over 192.168.1.0/24 and 2.0 / 24 routing information loaded into the routing table, labeled R & lt . While R2 and R3 and running OSPF ,ccnp bgp troubleshooting, establish OSPF adjacency, R2 also from R3 , by OSPF learned the two routes: 3.0 and 4.0 / 24 , is also loaded into the routing table, labeled O . So, for R2 , it has its own route to the whole network, but inside R2 , we can understand this : it will not change the route learned from RIP .The OSPF route is told to R3 , and the route learned from OSPF is not sent to R1 as a RIP route . For R2 , although there is complete routing information in its own routing table, it is as if there is a gap between the entries of R and O , which cannot be exceeded.