which is easier ccnp route or switch

which is easier ccnp route or switch

Flag: 0x860 Access switch configuration: Ok, then let's start the experiment below: Must be a zero field. Redistribute rip metric 10 subnets distribute-list 1 out rip Ip route 10.1.1.0 255.255.255.0 10.1.254.1 TCP Manually configure a secure address on the trunk interface to associate the vlan keyword. If the security address is manually configured on the trunk interface and the vlan keyword is not associated , the security address will be associated with the native vlan of the trunk . Match community 30 2.2.2.0 Routing Although the next hop is directed to R1 , it does not use the outbound interface to create routing entries. From the experimental phenomenon, it is not matched by the match . Needless to say, 3.3.3.0 , the associated interface is s0/1 . Enhanced Interior Gateway Routing Protocol (EIGRP) Open Shortest Path First (OSPF) The third column is empty or i . If it is empty, the route is obtained from the EBGP neighbor. The i indicates that this is the route learned from IBGP . The last column indicates the origin of the BGP routing information. Router ospf 1 Show ip bgp dampening NEXT-HOP V1 defaults to send v1 to receive v1, v2 BGP table version is 3, local router ID is 4.4.4.4 Set the primary root and secondary root. With primary ,which is easier ccnp route or switch, the default priority of the network (both 32768 ), the switch spanning tree vlan priority is adjusted to 24576 , if it is secondary , it is 28672 . But if there is a switch with the lowest priority: 4096 in the network, then this command is not. In other words, this command is to detect the bridge priority of other devices in the current network, and to adjust its own priority and ensure the minimum, it is as simple as that.