spoto ccie blog

spoto ccie blog

Sup7_E#sh license summary Sup7_E#sh license all no sh Activate first Standby hot is normal. Prepare the engine. Will take over the main engine at any time. BS sets the correct mode boot-end-marker The device is the ASA5510 Sup7_E#license install bootflash:FOX1509GTJU_20111127185652223.lic Two Juniper ISG1000s of ISBL are A/S, and two Juniper ISG1000s of OSBL are A/S. Since the internal NMS4.0 manages the egress gateway, the egress switch also has Juniper SA4500 VPN. Concentrator. Therefore, in addition to the need to put SNMP traffic on the FW, which traffic needs to be released? network 192.168.0.0 0.0.255.255 area 0 Last Failover at: 00:54:51 UTC Jan 1 2003 Password: (agent password) CO : (Applicant's CCO account) The operator will ask for the serial number of the equipment, service contract number, fault information,spoto ccie blog, contact information, etc. Rong. Then a CASE number will be assigned to you, and the TAC engineer will contact you. Failover On When filling in the PID and SN in the third step, you must not fill in the wrong one. PAK can only be used once. If the PID and SN are incorrectly filled. It is necessary to open CASE to CISCO. It is very troublesome and wastes time, such as some modular routing. Switching devices have many PIDs and SNs. For example, there are chassis, engine, power, no matter how many but as long as you execute the show license udi command to see which it is. This time I did not find the official information before entering the chassis PID and SN. The result is a living the license file is reported incorrectly when it is installed in the router. Finally, it is still very troublesome to write an email to license@cisco.com so be sure to fill it out correctly.