ccnp route chapter 5 exam answers

ccnp route chapter 5 exam answers

Hard reset Access-list 1 permit 10.1.1.0 (2) By default, the routing entry of 1.0.0.0 updated by R1 is ignored. After configuring ip rip receive v 1 on S0, you can learn. BGP metric is set to IGP metric 192.168.255.0/24 . Switch(config-if)# switchport trunk native vlan ? Preference , will trigger Notifacation message , causing session interruption; but can use IN on AS border router The configured static network path is redistributed into OSPF . In this way, when the intranet user needs to access the Netcom resources, because of the details of the network access, go to OR1 . To access other resources, take the default route to OR2 . By default , the rate on the DAI untrusted interface is 15 pps , while the trusted interface is unlimited. When an RSTP switch detects a topology change it will: Heavy FAQ published VTP Version capable In direction Let's look at the above scenario, focusing on the egress router. This egress router is a three-layer link with the Layer 3 switch. Therefore, you need to configure the backhaul route to the intranet, which is the red font part in the above picture. In this scenario, There are only three network segments on the intranet, so three static routes are configured, but what if there are 100 network segments? Do you want to have 100 routes? As a result, the routing table becomes very large and bloated, which is very inconvenient to maintain and manage. More importantly, this undoubtedly wastes resources of the device. Therefore, from the perspective of network optimization, no matter what kind of network model, we need to keep an eye on the number of routing entries in the router routing table in the network,ccnp route chapter 5 exam answers, whether it is sufficient for optimization, and whether there is room for optimization.