ccnp switch chapter 10 exam answers

ccnp switch chapter 10 exam answers

Adjust the management distance of the routing protocol 54 Update behavior Administrative distance problem Neighbor 4.4.4.4 update-source Loopback0 neighbor 10.1.25.2 remote-as 200 [abcd] One solution is that SW1 does not insert opiton82 , another method is to use the configuration on the DHCPserver : *>i100.0.2.0/24 200 300 By using route tags in RIP , you can control the redistribution of related routes in other protocols. When republishing to other protocols, RIP routes simply compare the tokens assigned to them without comparing the entire route. Redistribute ospf 3 subnets route-map OSPF3to1 router ospf 2 MED does not inherit Ip arp inspection vlan vlan_range logging { acl-match { matchlog | none } | dhcp-bindings { all | 1,10 3.3.3.3 Therefore, when the deployment is re-released, this problem needs special attention. As for how to avoid the problem, I will introduce it in the following content. Bgp cluster-id 222.222.222.222 Bgp confederation identifier 345 bgp confederation peers 64512 neighbor 4.4.4.4 remote-as 64512 About PBR 80 Network without mask is a class declaration, plus the mask is no class declaration Auto: passively wait for other side to ask Switch(config-if)# switchport nonegotiate !! Take the default route Match community 11 Non-equivalent load balancing Configuring the DAI loggin Message System , the system messages will each length_in_seconds transmission number_of_messages rate constraints to transmit system messages. number_of_messages default is 5 , the range of 0-1024 , if configured as a 0 indicates that the entry occurs only in the log buffer without generating system information; A length_in_seconds default lS , the range 0-86400 ( . 1 day), if the configuration is 0 then the Indicates that the system message will be generated immediately,ccnp switch chapter 10 exam answers, and the entry is no longer stored in the log buffer .