ping-t ccnp switch

ping-t ccnp switch

!! Match, go this one In the above configuration, the maximum number of secure addresses is set to 3 , and then a secure address is manually configured. Then there are two remaining , and the switch can construct a secure address through dynamic learning. Route-map WT2 permit 20 match ip address prefix-list 2 set weight 200 GLBP automatically manages the allocation of virtual MAC addresses and decides who is responsible for handling the forwarding work. These functions are performed by AVG ( active virtual There are 2 forwarders (1 active) ? The front is to use static routing. If dynamic routing protocol is used, the situation is different. For example, IGRP or EIGRP , the network specified by the ip default-network command must be obtained through IGRP or EIGRP (declaration, learning or redistribution). ), the default route can be dynamically passed to other protocol routers. R3 and R4 , R4 and R5 establish IBGP neighbor relationships,ping-t ccnp switch, and R3 R4 R5 uses LOOPBACK as the update source and refers to the neighbor . To increase the reliability and redundancy of the network, we let R1 and R2 are 100.0.1.0 and 100.0.2.0 injected into BGP , here is the simulation of a redundant environment, that we can through R1 , also by R2 Go to 100.0. 1.0 and 2.0 networks. ORIGINATOR_ID and CLUSTER_LIST 10.1.12.1 from 10.1.12.1 (1.1.1.1) In the BGP table, only one route is preferred, which should be R3 (because R3 's RouterID3.3.3.3 is less than R5 's 5.5.5.5 ) When the topology changes, the spanning tree protocol can detect these changes and automatically adjust the interface status in time to adapt to network topology changes and achieve link redundancy. Metric Set ip next-hop recursive *> 100.0.2.0/24 Neighbor 4.4.4.4 update-source Loopback0 ? PS : When the same router has two static routes to the same destination, the outbound interface and the next hop are used respectively. The two routes are load balanced (because the AD value and the metric value are equal). The static route configured by the outbound interface is imported into the routing table as a directly connected network. For details, see the static routing part of this document.