ccnp route quick reference pdf

ccnp route quick reference pdf

FastEthernet0/0 Network KEEPALIVE message If the result of the search finds an exact match, the data is forwarded according to the returned port number. Other solutions,ccnp route quick reference pdf, we will continue to introduce in the following experiments Match ip address prefix-list 11 set as-path prepend 600 Ip community-list 11 permit 100:11 IP address 16 bits Exactly the same, except that the list of AS numbers belong to the local Federation AS Network 172.16.10.0 mask 255.255.255.0 Aggregate-address 192.168.0.0 255.255.0.0 as-set advertise-map adv 100 * i100.0.2.0/24 1 PC2 is a new host access, arranged 192.168.0.1 address, the address after the completion of the configuration, PC2 transmits to the network a Gratuitous ARP , to prevent someone within the network using the same IP address, the Gratuitous ARP is senderIP and target IP All are themselves, senderMAC is its own MAC . 15 1,10 3 The configuration is as follows: TCP Ip route 172.16.0.0 255.255.0.0 192.168.12.1 RIPv2 supports authentication by changing the field in the RIP message that should normally be the first route entry . In the single update message with authentication , the maximum number of route entries that can be carried is reduced to 24 . 10.1.34.3 from 10.1.34.3 (3.3.3.3) Non-exist-map tabel-map 3.3.3.3 By default all routes belong to this community Router b 300 10.1.31.0/24 This subnet has been successfully updated " 10.1.31.0 " because it is the same as the main source of the R1 update source interface . Lowest sender bridge ID Configuring BGP Federal FastEthernet0/0 - Group 1 State is Active LocPrf Root SW1 receives the RLQ request and immediately responds with an RLQ response to inform that it is still alive. basic configuration IBGP session principle BGP routing rules 1 No community attribute Route Tag RouterB routing 100.100.100.0/24 passed to A , NEXT_HOP is 10.1.123.2 ; Note that the data exchange process is different for different products. The above process is the result of testing on the CISCO device (server). Define the gateway IP assigned to the client R2(config)# access-list 1 deny 192.168.3.0 R2(config)# access-list 1 permit any R2(config)# router ospf 1 Receiving behavior Note that there must be three layers between the DHCP server and the trunk interface. Because the unicast packet is relayed, the source address is the trunk interface configured with ip helper-address . Therefore, when the DHCP server returns the packet, the destination IP address of the packet. This is the interface IP of the interface configured with ip helper-address . SW1 still turns on dhcp snooping and inserts option82 Detailed command Manual network through BGP , which originated from IGP , because BGP network must guarantee the network 100 Dhcp-snooping Kanga sends an arp request, requesting Milne 's mac , then The Spanning-tree portfast feature cannot be configured directly on the trunk mode interface, otherwise the CISCO IOS will not take effect even if it is configured , unless the interface becomes access mode. If you really need to configure on the trunk interface, for example, if the interface is connected to a server that supports trunks , then add the trunk keyword to the Spanning-tree portfast command .