ccnp tshoot format

ccnp tshoot format

In R1 the ip route 0.0.0.0 0.0.0.0 null 0 then re-released in a static routing process, but also to !! The default VTP prunnig is off Dot1q None The smaller the MED, the higher the priority Passed between peers . If the route attribute of the route received between EBGP peers carries Local Preference , it will be triggered. Bindings are just special address pools. There is no limit on the number of manual bindings,ccnp tshoot format, but you can only configure one manual binding per host pool. Set extcommunity cost pre-bestpath 1 10 Ip route 0.0.0.0 0.0.0.0 null0 router bgp x If an OSPF in- process route cannot be summarized: Switch(config)# vlan 20 3.3.3.3 When the router is adjacent to the host, they learn in some way. The default priority is 32768, and the range is 0-65535 . The first 4 bits are the priority . The last 8 bits are used as the system id . The smaller the better , the multiple of 4096 . FastEthernet0/0 About route reflection clusters BGP table version is 3, local router ID is 4.4.4.4 Address-family ipv4 unicast This command can be used in the following ways: The RID is the largest IP address on the router and tends to be assigned to the loopback address. It can also be set manually by the bgp router-id command. If a path contains an RR attribute, the route generator ID ( originator ) will replace the RID in the optimal path selection process. Dampening takes effect only on EBGP routes and invalidates IBGP routes. Case: Problems in the environment of education and telecommunications dual-export NAT network through PBR Policy-based Routing (PBR) Policy Routing 80 Configuration example 58 The IBGP neighbor relationship is as shown in the figure. The neighbors are built using their respective loopback ports. After receiving the route, R2 continues to pass the IBGP neighbor R3 . In this case, R3 is the RR . Therefore , the route sent by the non- client IBGP neighbor is forwarded to its client R4 . At this time, R3 adds the ORIGINATOR and CLUSTER_LIST attributes to the route. , where the ORIGINATOR attribute is R2 's routerID is also 2.2.2.