ccnp tshoot exam answers

ccnp tshoot exam answers

The configuration of R3 is similar. Therefore, the role of the no-prepend keyword is: Do not prepend local-as to updates from ebgp peers . If you advertise the route to the EBGP neighbor of the primary AS , the secondary AS number is not attached . Create secure addresses through dynamic learning, manual configuration, and stciky In R2 opened on loopback interfaces 2.2.2.0/24 , R2 both redistributed RIP into OSPF , they redistribute directly connected into OSPF BPDUguard Note: If it is an EIGRP environment, you need to implement unicast update, then the route update interface can not be PASSIVE (this is different from RIP ), directly use the neighbor command to specify the neighbor. If the interface is PASSIVE , even if the neighbor is manually specified , the EIGRP neighbor relationship cannot be established normally . If ip routing is enabled , the command is ignored (but the default route Ip route 0.0.0.0 0.0.0.0 x ) is displayed ; The mechanism of proposal agreement is very fast, because they are not limited to any timers. This handshake mechanism will quickly spread to the entire switching network end and can quickly converge when the topology changes. Because RIP appeared earlier, early routers used serial link interconnection (point-to-point links),ccnp tshoot exam answers, so RIP triggered updates only supported on point-to-point links, for Frame-Relay and Ethernet. In the multi-access interface, RIP trigger update is not supported , but the Frame-Relay point -to- point sub-interface is considered by RIP to be a point-to-point link, and the trigger update can be enabled.