ccnp 300-135 syllabus

ccnp 300-135 syllabus

BGP Design and Implementation Recommended Reading 10.1.34.0 is directly connected, Serial0/1 S 172.16.0.0/16 [1/0] via 172.16.3.0 S 172.16.3.0/24 [1/0] via 172.16.23.3 The path is rejected by the inbound BGP policy, and the router is configured with soft reset. / / Use this command to delete Ip community-list ? LocPrf * i FastEthernet0/0 RIP-2 Only Set ip next-hop Note that at this moment, although SW1 trims the traffic of vlan10 on the fa0/20 port , the fa0/20 port of SW3 does still release the traffic, but in any case, the PCs cannot communicate with each other. Demonstrate, know the role of allowed vlan . Of course, this is the way to manually trim. * i100.0.2.0/24 The aggregate-address command is used for BGP manual summarization. The following is a detailed explanation of all subcommands of the command. At the same time network 1.0.0.0 , then 1.0.0.0 will be announced 2. Pass the RIP update with an unnumbered address ( invalid source ) AS_Sequence is well understood. In the case where the above figure does not make any policy, the type of AS_PATH carried by the BGP route delivered to R4 is AS_Sequence . This is an ordered list of AS numbers. When R4 receives the route update, AS_PATH is 300,100 , The configuration of R2 is as follows: Suboption type Although the decision to forward the message is implemented by the FIB , the second layer of frame rewriting is done according to the information in the adjacency list. The second layer needs to be rewritten to include the second layer for frame forwarding. head. For Ethernet, it is the new source, destination MAC , and type field. E.g: 3.0 this route. This is an example of the use of a distribution list. Of course, it has a wider range of applications. MED setting method : ... Ip route 100.0.0.0 255.0.0.0 null0 abbreviation 10.1.12.1 from 10.1.12.1 (1.1.1.1) Circuit-ID type (1) Declare the loop port 2.2.2.2224 The default COST value of all ports on the switch will increase by 3000 ,ccnp 300-135 syllabus, so that the port of the switch is not elected as the designated port. Routing entry for 8.8.8.0/24 The port enters the forwarding state, and the bridge already has the designated port. the Next-Hop recursive This (recursive next hop ) broke the characteristics of the traditional hop-hop interface must be directly connected under the router IP restrictions. Recursive next-hop may not be directly connected to the network, as long as the relevant routes in the routing table are reachable. Generally, the recursive next-hop is unreachable, and the data will be handled by the route (generally the default route is matched).