ccnp switch 300-115 lab manual

ccnp switch 300-115 lab manual

* i At this time, actually R1 's loopback port to R2 needs at least 2 hops, then this time you need to configure both neighbor xxxx ebgp-mul 2 3.3.3.3 Command You must use neighbor in the BGP process to specify the BGP peer . They exchange routing information, as well as related attributes, not link status. Port 15 2) Activate TC while timer , and then send the TC- set BPDU out from all non-edge designated ports and root ports . In this way, topology change information quickly floods the network. OPEN message C 10.1.12.0 is directly connected,ccnp switch 300-115 lab manual, Serial0/0 Authentication is identified by setting the address family ID field to all 1s ( 0xFFFF ). ? A policy-list is like a route-map that only contains a match statement. If the TCP is successfully established, the BGP process sends an Open message to the neighbor and enters Opensent. Invalid timer No need to connect directly. Only TCP connectivity is required. RR can modify the cluster-id About PBR ? Known via "ospf 1", distance 110, metric 1 Detailed rules About PBR 80 If the above is replaced by EIGRP , the phenomenon is the same as RIP , R1 will declare 1.1.1.0 into EIGRP. RFC1723 // This command is used to advertise the real AS number of the AS outside the federation . SW1#show ip dhcp snooping binding Routing VS. Switched Campus Network Architecture (1) can learn the routing entries of R2 update, and the routing table is loaded with 3.3.3.3 In the BGP table, only one route is preferred, which should be R3 (because R3 's RouterID3.3.3.3 is less than R5 's 5.5.5.5 ) The "original Ethernet frame" is up to 1518 bytes, the IP MTU of 1500 , plus the source destination MAC address is 12 , the type field is 2 , CRC4 , plus 30 bytes of ISL encapsulation, which is 1548 bytes. In the above figure, if both ends of the PC belong to vlan10d , if the fa0/23 port of SW1 will vlan10remove off, then the PC will definitely not be able to communicate. Dhcp snooping binding database . as follows: Redistribution will only perform re-release actions on routes in the routing table. After the maximum number of allowed MAC addresses of the port-security interface is set , the security address entries associated with the interface can be obtained as follows: The cache extracts the destination interface , destination MAC address, etc. , which greatly speeds up packet forwarding. Network When ISP1 is down, and the interface of GW connected to ISP1 is DOWN , the data of PC accessing 100 network is switched to ISP2. Send Update package Origin IGP, metric 0, localpref 100, valid, internal Local Routing Protocols ORIGINATOR_ID and CLUSTER_LIST Set comm-list del delete route-map test permit 20 Ip community-list 1 permit no-export route-map test permit 10 200 Policy-list concept After Port-Security is enabled, related parameters have default configuration. Next hop 10.1.13.3, FastEthernet1/0 valid adjacency Ip route 172.16.1.32 255.255.255.224 192.168.23.3 ? Bgp connected eigrp Commands When a router receives an update from the neighbor router indicating that the previously reachable network is now unreachable, or has a route with a larger hop count, the router marks the route as unreachable and starts a suppression timer if If the router receives a newer update of the route before the timer expires, or has a better metric than the previous record, the router identifies that the route is reachable and deletes the timer.