ccnp switch 300-115 hsrp

ccnp switch 300-115 hsrp

None Aggregate-address summary address summary-only The network segment of the network local direct interface enters BGP , the MED value is 0 ; the network local static route enters BGP ,ccnp switch 300-115 hsrp, and the MED value is 0. Adding the summary-only parameter will only pass the summary route, and the detail route will be suppressed. The summary route generated in this case will lose the AS_PATH attribute of the underlying detail route , so there may be some hidden dangers. Route tag 1111 Message type 10.1.12.0 [110/128] via 10.1.23.2, 00:06:40, Serial0/0 Switch(config)# ip route 0.0.0.0 0.0.0.0 192.168.255.2 Fast forwarding Ip prefix-list 2 permit 100.0.2.0/24 route-map WT2 permit 10 5.5.5.5 Represents the upper layer protocol ( BPDU ), which is always 0. For the contents of this section, please refer to the relevant chapters of the path properties of this document. SW1#show ip dhcp snooping binding RIP update source problem BPDU , then he will send again. Therefore, for 802.1D , the root bridge will send BPDUs to all interfaces continuously . The non-root bridge will receive BPDUs from its own root port and send BPDUs to its designated port . Non-designated ports will not send. BPDU 's will only listen. The prefix list contains the serial number, matching from the smallest Static Routing Configuration description *>i100.0.2.0/24 Weight Sending when an error is detected usually leads to the termination of the BGP connection Routing via 192.168.12.1, Serial0/0 The following are five types of BGP packets and packet parsing: Router bgp 300 Weight * i At this time, he himself will still forward if he receives the data packet to 3.0.0.0 , but will not forward to other rips. Optional non-delivery O E2 1.1.1.0 [110/20] via 10.1.23.2, 00:06:40, Serial0/0 Show ip bgp That is, a site address, the MAC address, is reserved at this level to identify the only site on the network. Access-list 1 deny 192.168.0.0 0.0.255.255 In half-duplex mode, the CSMA/CD access method is adopted . Not advertised to any peer 200 1.1.1.1 (metric 65) from 1.1.1.1 (1.1.1.1) Hello time 3 sec, hold time 10 sec Next hello sent in 1.280 secs After " 10.1.20.0 " is passed to R2 , since the updated subnet is consistent with the R2 interface main network, R2 receives the update, and uses the interface mask /23 as the mask of the received RIP subnet, then R2 local loading This RIP route is 10.1.20.0/23 . In fact, the prefix length of the route is wrong. We can configure a secondary address on the R2 interface. In this way, RIP will use the mask of the secondary address (if configured) to receive the route. For example, configure R2 with 10.1.123.222/24 .