ccnp tshoot 7.0 instructor lab manual

ccnp tshoot 7.0 instructor lab manual

Vlans allowed and active in management domain 3.3.3.3 *>i100.0.2.0/24 R1 and R3 , R2,ccnp tshoot 7.0 instructor lab manual, and R5 establish an EBGP neighbor relationship. As a result, the directly connected network segments of all devices are also connected. In AS345 , the routes are also available. This is for BGP . We did not pay attention in OSPF declared the R3 's s0 / 0 and R5 is S0 / 0 interface. The above command calls the defined policy-list in the route-map ; multiple policy-lists can be called in a route-map . When the RR sends a route update to an EBGP neighbor, it will be aware of the existing CLUSTER_LIST attribute. Access port processing frame process The LSA sends the neighbor to the neighbor, so the local route is filtered, and the neighbor has (because the neighbor has received the LSA ). Address family identifier. When the value is 2 , it indicates the IP protocol. An entry stored in the log buffer can represent multiple packets. For example, the switch receives the same ARP from the same interface and the same VLAN. Use CDP to detect next-hop IP reachability in PBR environment (without optional parameters) Fast forwarding Private-vlan primary The configuration commands are as follows: The summary of the route is actually done by the operation of the subnet mask. For the following example: Ip route-cache flow show ip cache flow Activate Port-Security (on the trunk interface) It is allowed to write multiple next hop IPs , but these IPs must be the interface IP of the directly connected router . Experiment 2 Route tag 13 $ Ip arp inspection vlan 100 logging acl-match none ? ! The f0/0 port of the user has opened the arp proxy). For R3 , in the R1 and R2 , the destination MAC in the later arrival arp response message is placed in the arp table, and the association 2.2.2.2 (set to R1 ), After that, all the data packets going to 2.2.2.2 are directly encapsulated by the MAC address of the f0/0 port of R1 , and no ARP request is sent . When R1 is f0 / 0 port DOWN when the R3 's 2.2.2.2 of ARP before entry timeout, R3 are unable to ping through 2.2.2.2Until the arp entry times out, or manually clear the arp entry for 2.2.2.2 .