ccnp 300-115 labsim

ccnp 300-115 labsim

AS_CONFED_SET A list of unordered AS numbers on a path to a specific destination , using the method with AS_SET // to ignore 1.0 of On Adding the summary-only parameter will only pass the summary route, and the detail route will be suppressed. The summary route generated in this case will lose the AS_PATH attribute of the underlying detail route , so there may be some hidden dangers. 3.5 RSTP (802.1W) Dialer Dialer interface Switch(config)# spanning-tree vlan-id Multicast capability C 192.168.12.0/24 is directly connected, Serial0/0 1.0.0.0/24 is subnetted, 1 subnets Example 2 : Version 10.1.13.1 Route summary issues to be aware of ? The time interval between listening and learning states. Default 15S We know that the data of the VLAN that the switch can support is very large. If PVST+ is enabled , each VLAN has a spanning tree, and no spanning tree must have a separate identifier. If you need to use a MAC , then the MAC address pool. It must be unbearable. Between R1 and R2 , the original R3 and R4 are updated through a multi-access network, and BGP is run . s> 172.16.1.0/24 10.1.13.1 If a designated discarding interface issue proposal after, did not receive Agreement , it will slowly transition to the forwarding state, this process is a traditional 802.1D the listening-learning-forwarding process. This situation may occur when the peer switch does not understand the RSTP BPDUs or the port of the peer switch is blocked . Within the federation, both R3 and R4 belong to AS64512 . For R4 ( AS64512 ), R5 belongs to AS64513 , but for the federal outside, R3R4R4 is AS345 , and external extremities do not know that AS64512 and 64513 exist. Switch(config)# vlan 20 At the beginning of the network operation, all switches will send BPDUs from all ports . Everyone thinks that they are root . As the BPDUs flood and collect, according to the information contained in the BPDUs ,ccnp 300-115 labsim, everyone PK comes out and the root is elected. . After that, Root sends BPDUs in the default 2S cycle . All non- root switches receive BPDUs from their own root ports , and then send bpdus from their designated ports . It's a bit like us from the root pour a basin of water down, water down the tree Fengyun acyclic continuous flow from the top down. In addition, the non-designated port of the block will continuously receive the bpdu on the link and listen all the time. When it does not receive bpdu within a certain period of time , the link is considered to be faulty and begins to enter a new convergence phase. .