ccnp 300-115 cbt nuggets

ccnp 300-115 cbt nuggets

PS : At present, the Ethernet frames we use are basically Ethernet II frames. ... Metric ? !! GW has no other configuration about routing Experimental needs Catos port switch ID in the default priority 32 (priority . 6 th 'bit ) , the IOS switch default 128 (priority field . 8 bits) Configuration command 57 Offset-list offset list 78 Match the AS_PATH that does not contain any AS number , that is , the route in the AS . 802.1W ? Complete basic configuration 2 EtherChannel protocol About PBR Protocol overview The destination IP address of the route can only be the address of the natural network segment. As shown above, R1 , R2 , and R3 run RIP . In the initial situation, R2 will update its routing table to R1 , which assumes that there are three routes 1.0 , If the outbound interface is a broadcast interface, it may impose an additional burden ( ARP ) on the nodes under the interface or cause potential problems. Experimental verification AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd Distance vector routing protocol 9. DAI - Dynamic ARP Inspection Ip address 3.3.3.3 255.255.255.0 A standard ACL can only match the route prefix and cannot match the prefix length of the route. For example, if you want to fetch the 192.168.1.0/24 route and use access-list 1 permit 192.168.1.0 , the route is matched, but at the same time, 192.168.1.0/25 , /26 ... are also matched because the ACL cannot match the mask, or the prefix length. Furthermore, when using a standard ACL to fetch routes, it is recommended not to add an anti-mask,ccnp 300-115 cbt nuggets, otherwise the range of matching route entries will be larger and less accurate.