ccnp switch 300-115 book

ccnp switch 300-115 book

Use set excommunity cost x to set in route-map Go ahead and assign the interface of SW1 and SW2 to the PC to vlan10. Deployment points Y A route-map containing a set of match statements can be defined in advance as a list of commands called a policy-list. 0 100 0 200 i Metric Verify again, instead of detailed routing, use a summary route of ip route 10.0.0.0 255.0.0.0 , the next hop is R3 , the effect is the same as above, also take R3 . Therefore, as long as it is not the default route, as long as there is such a matching route in the routing table, the route is taken preferentially, and the route-map is taken without the route . By the original impact of routing attributes Ip route 0.0.0.0 0.0.0.0 serial s0/2 To verify which outbound interface is used for a particular traffic in destination-based load balancing, use Use the global configuration command: err-disable recovery psecure-violation After the TCP session is established, both neighbors must send an OPEN message. Both parties use the OPEN message to identify themselves and specify their own BGP running parameters. If the open message is accepted, a keepalive message is sent back for confirmation, and the update message can be sent after confirmation . The OPEN message contains the following: Bridge ID in the MAC , is the backplane of the switch MAC , the port ID in the MAC switch port MAC , all the view switch mac available Bgp bestpath as−path ignore This command, if configured, skips this rule The range of prefixes to match, ranging from ge-value to 32 Routing Protocols Encapsulation Status OpenSent 12 RIP database If there is a tag , compare the VLAN tag of the frame with the PVID of the port . If the two are consistent, proceed to the next step; otherwise, discard the frame. VTP version running VTP Domain Name VTP Pruning Mode VTP Traps Generation Match the previous character 1 or more times 10.1.12.2 Outline R1 and R3 , R2, and R5 establish an EBGP neighbor relationship. 1,20,ccnp switch 300-115 book,30 AS_PATH , and AS_PATH only when routing out this AS or BGP routers to update EBGP will change when neighbors in AS inside will not change, therefore, in the AS internal, anti-ring requires the use of split horizon. So how to solve the problem that R5 ca n't learn routing? The redistribute local route learned from the IGP routing protocol enters BGP , and the MED value inherits the metric in the IGP protocol. Route 1 : AS_PATH : 500 The IGP protocol, such as OSPF , declares a direct interface (the associated network segment). On the one hand, the network number corresponding to the interface will be imported into the OSPF routing process. On the other hand, the interface will activate OSPF and start.