ccnp route 300-101 test

ccnp route 300-101 test

The range of TAG values ​​in the external LSA Then the test lines will be powered up for detection. It is found that the 2nd and 3rd lines match, but the matching length of the 2nd line is the longest, so the final result: Soft reset BGP routing table entry for 100.100.100.0/24, version 5 Paths: (2 available, best #1, table Default-IP-Routing-Table) Multipath: eBGP Ip dhcp pool BIND Set ip next-hop [Synchronization concept] After a BGP router learns a route from an IBGP neighbor, it is not enabled (not optimized) unless it learns the same route from the IGP again . This is to prevent the routing black hole problem described above. R1 and R3 , R2, and R5 establish an EBGP neighbor relationship. 200 i Ip dhcp snooping vlan 10 Interface fast0/1 10.1.13.3 The above command creates a policy-list ; the Policy-list can only contain a match statement. ADJ-RIBs-OUT announces routes to peers The two networks of network 100.0 on R1 and R2 enter BGP , then the BGP table on R4 : Weight Path C 192.168.23.0/24 is directly connected,ccnp route 300-101 test, Serial0/1 Update timer update timer Receiver ( R1 ) In BGP , the network command has nothing to do with which interfaces BGP runs. Just inject a local network into BGP . This route is called reliable. Only the route exists in the router's routing table (not B ). It is possible for the network segment in BGP to pass the route entry to the BGP neighbor. It is important to note that the network can only effectively inject non- B routes that exist in the routing table . If I have a local the Loopback , 4.4.4.0/24 and I BGP in Network 4.0.0.