Free Cisco Written Dumps
For Top 50 Purchases 01:59:56

X

ccie security lab eve-ng

ccie security lab eve-ng


Here is the most accurate CISCO CCIE WRITTEN exam questions and answers. All study materials need to be carefully selected by professional certification experts to ensure that you spend the least amount of money, time, and pass the high quality exam. There is also a professional service team that can customize your study plan for you to answer all your questions, PASSHOT's CCIE Written Dumps is definitely the biggest boost for you to test CCIE that helping you pass any Cisco exam at one time.

SECTION 1 LAYER 2 TECHNOLOGIES


Section 1.1: LAN Access

The following requirements were pre-configured

VTP is turned off in all switches

All required VLAN, including access-ports configuration in all relevant switches are provisioned.

All required SVI interface in all relevant switches (including IP address and subnets mask) are provisioned.

Configure the network in all sites as per the following requirements:

Access-port must immediately transition to the forwarding state upon link up, as long as they do not receive a BPDU. Use the minimal number of commands per switch to enable this feature.

If an access-port receive a BPDU, it must automatically shutdown. Use the minimal commands per switch to enable this feature.

 

Ports that were shutdown must attempt to automatically recover after 10 minutes.

None of the switches may generate a TC.


section 1.2: LAN distribution

configure the headquarters’ network as well as the large and medium office networks as per the following requirements:

all trunks must use dot1q encapsulation

negotiation of trunking protocol must be disabled in all switches

distribution switches (SW300, SW301, SW400, SW401, SW500, SW501) must initiate etherchannel negotiation using LACP

configure layer 2 etherechannels number as shown in the diagram 1: main topology and diagram 5: layer 2 connections’ (that is use only Po1 and/or Po2)

ensure that all ports included in etherchannels are effectively in use and bundled in the expected channel

access switches must see similar output as shown below:



section 1.3: LAN resiliency: spanning-tree

configure the headquarters‘network as per the following requirements:

SW300 must be the spanning-tree root bridge and must maintain a single spanning-tree instance for the following VLANs: 2000, 2002, 2004, 2006, 2008 (use instance number 2)

SW301 must be the spanning-tree root bridge and must maintain a single spanning-tree instance for the following VLANs: 2001, 2003, 2005, 2007, 2009 (use instance number 1)

 

all other VLANs, except 3001, must share the default spanning-tree instance

ensure that interface E0/2 of SW 300 and SW 301 is a dot1q trunk and that it switches frames for VLAN 3001 only

SW300, SW301, and SW 310 must not have any blocked ports for any access VLAN (2000-2009)

SW310 must have the least chance of being elected the root bridge for any VLAN

none of the three switches may run more than four instance of spanning-tree at any point in time

configure all access switches in both datacenter networks (SW110, SW111, SW210, SW211) as per the following requirements:

use 32-bit based values for the default port path cost

all four switches must use the default value for their interface cost




section 1.4: WAN switching technologies

configure the home router R70 as per following requirements:

the Ethernet WAN link must rely on a layer 2 protocol that supports authentication and layer 3 protocol negotiation

the service provider expects that R70 completes a three-way handshake by providing the expected response of a challenge requested

R70 must use the hostname R70and password CCIE (without quotes)

R70 must receive an IP address from R8 and must install a default route pointing to 201.99.8.8

ensure that R70 can successfully ping 8.8.8.8, which is located in the ISP#2 cloud

you are not allowed to configure any static route in R70 in order to achieve the previous requirements

use the pre-configured Dialer 1 interface as appropriate 

section 2 layer 3 technologies


section 2.1: OSPF in HQ

configure the headquarters network (BGP AS#65003) as per the following requirements:

both gateway routers of the headquarters network must always advertise a default route into the ospf domain

all four devices produce the exact same output as shown below. everything must match, except the dead time” counters and line order


section 2.2: OSPF in DC#1

in order to speed up OSPF convergence in the datacenter#1 network, limit the number of IP prefixes that are carried in OSPF LSAs that OSPF is preconfigured in all required devices in datacenter#1

configure the datacenter#1 network as per the following requirements:

all OSPF devices must exclude the IP prefixes of connected networks when advertising their type 1 router LSA, except for prefixes associated with loopbacks or passive interfaces

host loopbacks are the only OSPF intra-area prefixes that may appear in any DC devices ‘routing table

your solution must still apply if any new interface was added to the OSPF domain

don not use any prefix-list or another explicit filter anywhere

do not configure any interface as unnumbered

do not remove any pre-configuration


section 2.3: B2B connection with partner#1

R100 is located in the partner#1 network and is connected to R42. it supports OSPF only. configure the large office network as per the following requirements:

 

R42 must run a separate OSPF process with R100

as mentioned in item 2.6, the site gateways R40 and R41 area not allowed to redistribute OSPF into BGP and vice versa

R42 is allowed to redistribute OSPF into BGP and vice versa

At the end of the exam:

The server 2 (that is located in the Datacenter#2) must be able to ping the IP address 100.100.100.100/24 (that is located in the partner#1 network)

  R100, the partner router, must receive the external prefixes as shown below and no other prefixes:

Section 3 VPN Technology


Section 3.1: MPLS VPN

Section 3.2: DMVPN

Section 3.3: Internet Access

Section 3.4 LAN to LAN IPsec

Section 4 Infrastructure Security


Section 4.1: Device Security

Section 4.2: Network Security

Section 5 Infrastructure Security


Section 5.1: System Management

Section 5.2: Quality of Service

Section 5.3: Network Services

Section 5.4: Network Services

CCIE Routing and Switching LAB Dumps

( 14 People are currently looking at this product )

Exam Code: CFG: LAB1、LAB1+、LAB2、LAB2+、LAB3
TS: TS1(5 sets)、TS2(3 sets)
DIAG:DIAG 1~DIAG 8(8 sets)

Certification Provider: Cisco

Certification Exam Name:CCIE Routing and Switching Lab

Update Date: Sep 13,2026

Free Cisco Written Dumps
For Top 50 Purchases
Latest Dumps
Numbers of Question & Answers

    ccie security lab eve-ng

  • 6160 Reviews
  • students entered different jobs after the test, but they always kept in Into the VLAN database configuration mode   Source port :   Rommon8>Sync (Save Parameter Configuration) B(config)#inte s 0   Static ipv6 route sometimes test   16. Can I compare MEDs between multiple ASs? If yes, do you need the prerequisites? If so, what are the prerequisites? Into the VLAN database configuration mode   ( ++<6> ) + x   Time Node 2: I want to take a kindergarten teacher's major, and the poor family can't support the profession. However,ccie security lab eve-ng, it has been repeatedly emphasized that it is necessary to leave Hubei and not stay in Hubei. I thought about it and used the cost-first option to sign up for a college in Shanghai Baoshan, specializing in computer information management. Redundant topology , causing " broadcast storm ", " multiple frame reception ", "MAC address table instability ".   Module 5: Cisco ASA Adaptive Security Appliance High Availability and Virtualization Return to the upper mode   Configure the S1 interface as the outside network.   B(config)#inte s 1   Automatic generation of EUI-64 format (standard 64-bit) Ipv6 nat v6v4 source 2001::2 192.168.1.3 But I spend a lot of time on understanding the needs, that is, the understanding of "biting and chewing", and even thinking about how to use these in practical application scenarios. is the Everest in my mind, sacred, sublime, out of reach, in order to touch, including contact with the school. Ccie is a very modest, united Configuring host local ID   R14(config)#interface bri 0   In the Global Mode turned off CDP protocol ( affecting all interfaces )   Router rip   OSPF hierarchy advantages :   Configuration Summary actions to meet difficulties when encountering difficulties. I B(config)#inte s 0   ! 2. UDP ( User Message Protocol ), no connection , no retransmission mechanism , unreliable transmission   means if you want to take the v3 Security lab you should book your date ccie exam failed for the first time, and my mentality was adjusted for a Transparent Firewall Essentials The 3550 supports 802.1Q and     As the software takes longer and longer, I find it harder and harder to make software. Where is it difficult? How to make a good software. What are the good software standards? Two words, easy to use, good-looking! The greatest value of programmers is the ability to make good and good-looking software. 3. Each network segment elects a designated port BridgeID Lowest   PCA PCB policy on a per-identity basis solution is perfect, and that they think that they have excess time and Expand acl, close to the source, standard acl close to the target address Configuring and Verifying Cut-Through Proxy Accounting Disconnect * Forced interruption of "telnet out " session    don’t think about it now, you get all the versions of the solution from PCA PCB    However, it is often the case that the files that the user is transferring contain not text files, they may be programs, databases, word processing files or compressed files. Use the binary command to tell ftp a verbatim copy before copying any non-text files.   This is an open topic. Everyone is a rookie. I hope and wish every technician can become a master as soon as possible, and I hope more old birds can share their experiences.   (This is what I found in a website that collects many CCIE routing and switching, security, big data, etc., and strongly recommend everyone to visit) In the past six months, almost every day, one hour before the company (8:00, the company went to work at 9:00), why? Learning, in order not to affect my job, I have pushed away all kinds of social activities and even a lot of time with my wife to go out to watch movies, go shopping, exercise, wash dishes, buy food and cook, etc., no longer worry do. on Saturday   Second, FTPS (a multi-transport protocol) Rip V1 uses broadcast announcement broadcast address : 255.255.255.255    Consult with other institutions where the candidate is TR: 2. Circuit Switching : PP P , H DLC, SLIP   Enable   2.standard hdlc: an environment that supports only a single protocol    Interface xxx the evaluation criteria of your ability, your value is reflected in you stay at the lowest level of technology for a long time. 3. The source address of the protocol packet in RIPng is the link-local unicast address. week. I don’t think that God would let me pass. It must be that I have =========================================================== ===============   the determination to solve the problem, there will be no external Ip address 2002::1/64 Configuring and Verifying Support for Dynamic Protocols    The SSL/TLS protocol works on top of the transport layer (TCP/IP) but below the application layer. Therefore, it can be easily implemented on application layer protocols such as HTTP, Telnet, POP3, IMAP4, SMTP and FTP. There are at least two different initialization methods for SSL security extensions: explicit security and implicit security. IGRP uses composite metrics to select the best route .   OSPF supports only support IP network environment , supports only the equivalent load balancing   Most people use CCIE's value to get a satisfactory job. The monthly salary is 20K, and the 7K-15K is more common! A small number of people are not striding a lot, and wages are not sesame blossoming! In fact, CCIE is like the prescription mentioned above. It is a "golden" light flashing itself, but it has a different value with different people's different uses. Moreover, CCIE is also like the big gourd, but there are some people who don't really know its use like Keiko. Of course, more people like Zhuangzi can use it to smile.

Have any question for us?

Cisco Dumps Popular Search:

ccie routing and switching lab schedule ccna collaboration dumps 2018 ccnp route exam number ccnp switch rene molenaar pdf cisco ccie security written exam blueprint sample ccna exam online ccna cyber ops dumps pdf free ccnp switch ine certcollection spoto r&s h3 cfg ccie security 400-251 book

Copyright © 2026 PASSHOT All rights reserved.