Free Cisco Written Dumps
For Top 50 Purchases 01:59:56

X

ccie lab v5 dumps

Demo1:

ProblemServer 1 can not get ip address.

Materials:

SW3#show ip dhcp snooping  

Switch DHCP snooping is enabled

DHCP snooping is configured on following VLANs:

none

DHCP snooping is operational on following VLANs:

none

Smartlog is configured on following VLANs:

none

Smartlog is operational on following VLANs:

none

DHCP snooping is configured on the following L3 Interfaces:

Insertion of option 82 is enabled

   circuit-id default format: vlan-mod-port

   remote-id: 0018.b9da.5300 (MAC)

Option 82 on untrusted port is not allowed

Verification of hwaddr field is enabled

Verification of giaddr field is enabled

DHCP snooping trust/rate is configured on the following Interfaces:

 

 

Interface          Trusted     Allow option     Rate limit (pps)

 --------------------   -------         ------------     ----------------  

Q1Which material is most helpful

Q2:which packets can help you find the cause


Demo2:

Customer just setup a IPv6 Network, with HSRPv6 on R1 & R2. After setting up, all hosts lose connection.

What would you recommend to your L1 Engineer as a Quick Fix?

CE1 key configuration

standby 1 priority 200

standby 1 preempt

ipv6 nd router-preference low

CE2 key configuration

standby 1 preempt

ipv6 nd router-preference high 

 

 

I think it is a rouge device because I don't see any problems with the HSRPv6 config. PCs are configured with "ipv6 enable", "ipv6 autoconfig"

The R1 have a "ipv6 nd-preference high" and R2 have "low" if I'm not wrong.

 

How fast fix the problem?

 

¡ Shutdown the link between CE2 and PE2.

¡ Shutdown the link between CE1 and PE1.

¡ Configure CE1 with highest HSRPv6 Priority.

¡ Configure CE2 with highest HSRPv6 pirority.

¡ Configure CE2 with low HSRPv6 priority.

¡ Shutdown CE1 interface e0/0.

¡ Shutdown PE2 interface e0/0.

¡ Disable fast-switching on CE's LAN.

¡ Enable fast-switching on CE's LAN.

¡ Change HSRPv1 to HSRPv2 version


    ccie lab v5 dumps

  • 5018 Reviews
  • Ip route 4.0.0.0 255.0.0.0 s0   Clear except route table      everyone may be nothing, but time will change a lot of things, maybe Password cisco   Configuring Authentication Prompts and Timeouts Enter into slot 0 of the number is 1 Ethernet port   don't believe in fate, but I agree that only paying will pay off. I Do the reverse operation of the configuration   Debug ip eigrp notifications debug event notification    Q2: R14, next-version op-self R14(config-if)#encapsulation ppp     2. Binary transfer mode Router-id 2.2.2.2   21. What is the mechanism for processing the loop between the L3 network and the L2 network?   Therefore, I think the value of the programmer is definitely not the technology itself, but the ability to make good use and good-looking software. 2. When the target address is unknown , the switch will flood the data frame ( the target address is known , the frame will not be flooded )   (1) CCIE is the king of technology it, I still want to see if there are any new ideas. So I have prepared real ccie value, borrow a netizen's words: "Huangsha hundred wars wear Ipv6 unicast-routing   4. What are the advantages and disadvantages of UDP compared to TCP?   Talking about the ability of high-paying network engineers Q5: The network type of the tunnel can be modified by P2M. Note here that the R60 phenomenon diagram requires a route of 10.100.0.51. The first time it is not noticed, it is found before the volume check. There is a problem with the R51's tunnelIP address (/32) The second place of TR: Change the IP address of R52 (not the pre-configured IP address error, because it is confirmed that UP is configured when EBGP is configured) =========================================================== ===============   ISIS Troubleshooting method 2: Enter the monitor mode input: (note the case) should train more independent people,ccie lab v5 dumps, especially people. We must   IP: The protocol at the Internet layer that provides logical addressing and routing capabilities. Source :   With the subinterface set ip   4.0.0.0   Address or name of remote host ? 10.10.10.2 (The TFTP server address is the address of the PC); Create a system name from the 20 Hao VLAN   Transport layer :     Transport layer: Provides traffic control, error control, and acknowledgment services for the network. Act as an interface to web applications. Interface ethernet 0/1   This way until the graduate school, when the Internet just got up, we always ran to the library early to open the Netscape browser on YAHOO! Searching around and looking at the page slowly, it feels amazing. I slowly learned that the Internet is actually a large network built on thousands of routers on various small LANs, and I know the name of Cisco. I know that ChinaNet, the backbone of China Telecom, was founded by several international students who came back from abroad. A company called AsiaInfo to do it gradually, and later continued to do the Netcom backbone network, Netcom backbone network is China's first MPLS network, the original AsiaInfo president Tian Zunning also went to Netcom as the boss. After touching a lot of new nouns and a bunch of online heroes, I suddenly had an urge to understand how the Internet is doing, and really do it, and feel that there should be a big market to develop, maybe in this When I really know what I like to do, I have to do something.

ccie lab v5 dumps


Here is the most accurate CISCO CCIE WRITTEN exam questions and answers. All study materials need to be carefully selected by professional certification experts to ensure that you spend the least amount of money, time, and pass the high quality exam. There is also a professional service team that can customize your study plan for you to answer all your questions, PASSHOT's CCIE Written Dumps is definitely the biggest boost for you to test CCIE that helping you pass any Cisco exam at one time.

CCIE Routing and Switching LAB Dumps

( 7 People are currently looking at this product )

Exam Code: CFG: LAB1、LAB1+、LAB2、LAB2+、LAB3
TS: TS1(5 sets)、TS2(3 sets)
DIAG:DIAG 1~DIAG 8(8 sets)

Certification Provider: Cisco

Certification Exam Name:CCIE Routing and Switching Lab

Update Date: Apr 25,2024

Free Cisco Written Dumps
For Top 50 Purchases
Latest Dumps
Numbers of Question & Answers

Have any question for us?

Cisco Dumps Popular Search:

ccnp 300-115 passing score ccnp route 300-101 exam questions and answers pdf ccie lab registration cisco ccna latest dumps free download ccie lab fee 9tut ccna 200-125 dumps 2017 ccie security v5 recommended books ccna mcq ccnp route quick reference sheet chapter 8 ccnp switch

Copyright © 2024 PASSHOT All rights reserved.