Free Cisco Written Dumps
For Top 50 Purchases 01:59:56

X

ccie lab diagnostic questions

Demo1:

ProblemServer 1 can not get ip address.

Materials:

SW3#show ip dhcp snooping  

Switch DHCP snooping is enabled

DHCP snooping is configured on following VLANs:

none

DHCP snooping is operational on following VLANs:

none

Smartlog is configured on following VLANs:

none

Smartlog is operational on following VLANs:

none

DHCP snooping is configured on the following L3 Interfaces:

Insertion of option 82 is enabled

   circuit-id default format: vlan-mod-port

   remote-id: 0018.b9da.5300 (MAC)

Option 82 on untrusted port is not allowed

Verification of hwaddr field is enabled

Verification of giaddr field is enabled

DHCP snooping trust/rate is configured on the following Interfaces:

 

 

Interface          Trusted     Allow option     Rate limit (pps)

 --------------------   -------         ------------     ----------------  

Q1Which material is most helpful

Q2:which packets can help you find the cause


Demo2:

Customer just setup a IPv6 Network, with HSRPv6 on R1 & R2. After setting up, all hosts lose connection.

What would you recommend to your L1 Engineer as a Quick Fix?

CE1 key configuration

standby 1 priority 200

standby 1 preempt

ipv6 nd router-preference low

CE2 key configuration

standby 1 preempt

ipv6 nd router-preference high 

 

 

I think it is a rouge device because I don't see any problems with the HSRPv6 config. PCs are configured with "ipv6 enable", "ipv6 autoconfig"

The R1 have a "ipv6 nd-preference high" and R2 have "low" if I'm not wrong.

 

How fast fix the problem?

 

¡ Shutdown the link between CE2 and PE2.

¡ Shutdown the link between CE1 and PE1.

¡ Configure CE1 with highest HSRPv6 Priority.

¡ Configure CE2 with highest HSRPv6 pirority.

¡ Configure CE2 with low HSRPv6 priority.

¡ Shutdown CE1 interface e0/0.

¡ Shutdown PE2 interface e0/0.

¡ Disable fast-switching on CE's LAN.

¡ Enable fast-switching on CE's LAN.

¡ Change HSRPv1 to HSRPv2 version


    ccie lab diagnostic questions

  • 2231 Reviews
  • Configuring and Verifying Interface ACLs   Network Access Layer: Provides an interface to the physical network. For the structure of the transmission medium setting data, the addressing of the data is realized according to the physical address of the hardware, and the error control of the data transmission in the physical network is provided. Configure local username   2.GRE P2P site is always no way to make a lot of money. Sometimes the income of a Q: How do you get multiple CCIE qualifications to help you go all out to achieve your career goals? Q: In the last days, will you qualify for the fifth CCIE? dare not face all kinds of challenges. I hope that like the school, Firewall Technologies   Application layer: Provides applications for network troubleshooting, file transfer, remote control, and Internet operations. It also supports application programming interfaces (APIs) that enable programs written for specific operating systems to access the network. View the configuration of the   interface 's acl Troubleshooting method 1: xmodem –c newflash_name command upgrade Cisco ASA Adaptive Security Appliance Licensing Requirements Ipv6 address 3FFE: FFFF: 1:: 1/64 Today, BJ-Andy started to be too embarrassed. I elaborated on my experience of being TR (plus mistakes), not blowing it! ! . (I just remembered it three times, but then calmly thought about it not only a few times) 1. In your living room (B) front door (B s0) an iron gate (ACL), not let the thief come in (in), so that you can achieve the purpose LMI: Local Management Interface .   10.1.1.1/0.0.0.0   IPV6 worldwide unicast addresses also have standard prefixes No shut   Configure the IP address of the   interface . Q1: Vacl, deny all by default, add one to release Return directly to privileged mode   Tunnel destination 200.200.2.1   analysis On the interface enabled with PPP   Frame-relay lmi-type ansi     TCP (Transmission Control Protocol): A reliable, connection-oriented protocol in the transport layer. BECN: Backward explicit congestion notification   Features: Head 8 fixed 1111 1111 = F Worldwide unicast address: similar to the public address in IPV4, mainly used in the global Internet         This is an open topic. Everyone is a rookie. I hope and wish every technician can become a master as soon as possible, and I hope more old birds can share their experiences. Troubleshooting method 3: 1. Install the flash card of the intact router on the faulty router to boot; VTP uses multicast to advertise, and VTP will advertise every 5 minutes , even if there is no change here.   In fact, the application of in and out is very flexible. (3) CCIE is more expensive Going back at night, the teacher didn't ask much, just said: If you don't want to brush, I will help you brush it. I have eaten, my heart is very embarrassed, my body is uncomfortable,ccie lab diagnostic questions, 9 o'clock, the results did not come out, ten points have not come out, it was really a bit of a collapse, people said that the night before the exam and the night after the exam is the most Difficult, it seems that this is true, because there is no rest in the day before the first exam. It is too tired after the test. At 11 o'clock, I can't help myself. I am going to shut down the computer and go to sleep. I accept it. I got an email from Cisco for my grade notification. Refreshed once, when I saw the PASS moment, I really relaxed completely, I passed, and finally passed. . . I called all my relatives and friends and let them share my happiness.

CCIE Routing and Switching LAB Dumps

( 3 People are currently looking at this product )

Exam Code: CFG: LAB1、LAB1+、LAB2、LAB2+、LAB3
TS: TS1(5 sets)、TS2(3 sets)
DIAG:DIAG 1~DIAG 8(8 sets)

Certification Provider: Cisco

Certification Exam Name:CCIE Routing and Switching Lab

Update Date: Dec 21,2024

Free Cisco Written Dumps
For Top 50 Purchases
Latest Dumps
Numbers of Question & Answers

ccie lab diagnostic questions


Here is the most accurate CISCO CCIE WRITTEN exam questions and answers. All study materials need to be carefully selected by professional certification experts to ensure that you spend the least amount of money, time, and pass the high quality exam. There is also a professional service team that can customize your study plan for you to answer all your questions, PASSHOT's CCIE Written Dumps is definitely the biggest boost for you to test CCIE that helping you pass any Cisco exam at one time.

Have any question for us?

Cisco Dumps Popular Search:

ccie lab device list ccnp route 300-101 exam labs ccie lab demo buy ccna dumps ccnp 300-101 lab pdf ccnp switching labs in packet tracer exam code of ccna ccnp route hands how many question in ccnp tshoot exam ccna routing and switching latest dumps

Copyright © 2024 PASSHOT All rights reserved.