cisco vce exams

cisco vce exams

Interface loopback Inter-area IP routing changes; Then apply the ACL on R2 , connect to the interface of R1 , in the direction R5 configuration is as follows / / View the basic parameters of the protocol We see that R1 these inter-area routes are still there,cisco vce exams, but R1 no longer refers to the default route to R2 . Perform routing protocol functions in the routing domain ! 200 Tunnel mpls traffic-eng autoroute metric absolute 32 Backbone area Selection: reoptimation Prior LSP: O bit Default route injection Manual re-optimization Area verification is actually the verification of Level1 area . After the area authentication is added to an IS-IS router, it will check the IS-IS packets it receives . If there is no authentication information or error in the packet, it will be ignored. The IS-IS packet generated by the device itself carries the authentication information. If the receiver does not have the configuration area authentication, the device can still learn normally after receiving the packet carrying the authentication information. The authentication information of the area authentication is only included in the LSPs packet. Other packets are not included.