ccna rs exam

ccna rs exam

Modify the configuration of R2 : Configured in OSPF process mode, this command activates MPLS TE in a specific area. 2.2.2.2 [110/65536] via 10.1.12.2, 00:00:47, FastEthernet0/0 ! The first is the case of no forwarding adjacency: neighbor is a neighbor of the LDP routerID accept acl to match the prefix *Aug 18 09:06:07.919: SENDER_TSPEC type 2 length 36: Router ospf 1 Configure this hidden command on the penultimate hop router (that is, R2 in the figure above ): Above we can see the reservable bandwidth of all tunnel priorities. Now let's modify the reservable bandwidth of the tunnel with priority 6 . Routing domain Pop tag IGP metric: 1 Record Route: NONE Experimental results: Tunnel mpls traffic-eng autoroute announce tunnel mpls traffic-eng priority 7 7 C It is also to check the FIB table, find 301 corresponding to the tag outgoing label is PoP and the next hop is D , then the head will pop up labels, which expose the original IPv4 data,ccna rs exam, C will be to the packet D . Ip address 10.1.12.2 255.255.255.0 When the LDP router from his LDP received from the neighbor label bundled neighbors, it will be bundled with the results stored in its own LIB table, LIB table has local label , which is distributed to its own specific routing prefixes label, Remote label it Is the label that the neighbor distributes for this route prefix. The LDP router will place the remote label assigned by the neighbor in the LIB , but will only select a possible outbound label from all possible labels in the LIB to be placed in the LFIB . The LDP router forms a LFIB table according to the LIB table and the routing table, as shown in the LFIB table of A in the above figure .