cisco practice exams ccna

cisco practice exams ccna

Load balancing of tagged messages 0x0000000E R2.00-00 For a router that supports IPv6 , the algorithm for performing load balancing on MPLS packets is as follows: 75000 kbits/sec, Interface Serial0/0 Brief introduction to the work process IGP metric: 1 Network 10.1.45.5 0.0.0.0 area 0 *Aug 18 09:06:07.919: version:1 flags:0000 cksum:0000 ttl:255 reserved:0 length:232 Ip address 4.4.4.4 255.255.255.255 Ip unnumbered Loopback0 tunnel destination 4.4.4.4 tunnel mode mpls traffic-eng Regional association. The L1/L2 router sets this field in the L1 LSP it generates to notify the L1 routers in the same area to connect themselves to other areas. Usually, the L2 backbone area is connected. When the router in the L1 area receives the L1 LSP from which the ATT bit sent by the L1/2 router is set , it creates a default route to the L1/2 router so that data can be routed to other areas. Although the ATT bit is defined in both the L1 LSP and the L2 LSP , it will only be set in the L1 LSP ,cisco practice exams ccna, and only the L1/2 router will set this field.