free ccna test questions and answers

free ccna test questions and answers

IGP Neighbor: ID 10.1.23.2 75000 Path calculation Priority 4 : 9375000 Router isis RFC1195 Or Tunnel Id Router isis The CLNS address is required even if it only provides routing for IP . Bytes tag 4.4.4.4 10.1.12.2 Run OSPF on the entire network to announce direct connection and loopback interface. R3.02-00 Outgoing interface ---------- 0 The configuration of R2 is as follows: Access-list 1 permit 5.5.5.0 route-map test permit 10 RSVP Signalling Info: ! The configuration of R1 is as follows: 0 kbits/sec Status Switched 75000 Local binding: tag: 100 Router isis *Aug 18 04:37:06.239: SENDER_TSPEC type 2 length 36: Seq# Checksum Opaque ID R1(config-keychain)#key 1 Note: The tunnel 's build priority cannot be set higher than the hold priority. O Metric: 10 i L1 i L2 R1#sh mpls forwarding-table The router in Lan establishes an adjacency with all other routers in the same LAN with the same area ID and hierarchy . !! Label protocol uses LDP (default is LDP ) Tunnel destination 4.4.4.4 tunnel mode mpls traffic-eng Through the above command, you can view the actual forwarding outbound interface and the next hop of the packet whose source is 10.1.35.5 and whose destination is 1.1.1.1 on R3 . We can see that the traffic of this source address is actually used. One hop is 10.1.34.4 , and the outgoing interface is F1/0 port. That is to say, as long as it is from 10.1.35.5 , the traffic to 1.1.1.1 is constant,free ccna test questions and answers, and the Fa1/0 port is constantly taken out.