ccna rs 200-125 dumps

ccna rs 200-125 dumps

Interface Serial0/0 ipv6 enable Set ip next-hop { ip-address [...ip-address] | recursive ip-address } Of course, the subnet 172.16.0.0/16 can be further subnetted to get 172.16.10.0/30 or even 172.16.10.1/32 , then if these prefixes exist, when I am going to find 172.16.10.1 , who's What is the highest match? Obviously, is the host prefix of 172.16.10.1/32 , or host routing? This is the longest match principle . EIGRP , BGP and other dynamic routes learned. Y Use a hold-down timer to prevent routing loops Image Routing Protocols Offset-list 1 out 10000 fastEthernet 1/0 Ipv6 unicast-routing interface Serial0/0 encapsulation frame-relay RFC2766 , RFC2765 . NAT-PT (Network Address Translation - Protocol Translation) is an address translation technique that translates IPv6 addresses into IPv4 addresses and vice versa. NAT-PT is based on the stateless IP/ICMP converter ( SIIT ) algorithm defined in RFC2766 . SIIT algorithm translation In label/Out label Ipv6 unicast-routing Neighbor discovery and adjacency formation mechanisms are the same Ipv6 prefix-list test seq 5 permit 2001:3::/64 Ipv6 router rip RIPprocess 10.1.20.0/24 This route is updated by R1 with " 10.1.20.0 ". This is because the subnet mask is consistent with the update interface mask /24 . The v1 update package does not contain a mask. The updated subnet only. number. Please see the three cups of Black Tea " IPv6 Notes", visit ccietea.com for the latest version. Focus on the configuration of GW : R3 Any Port-channel Ethernet Channel of interfaces None does not send updates ( passive ) E.g: Wherein, R2 back to R1 of ICMPv6 error message is as follows: Weight If R2 is added to the default route of R3 on the above basis,ccna rs 200-125 dumps, the data of the PC to the 10.1.13.0 network is still lost to R1 , which means that ip defaut-next-hop has higher priority than the default route. On the CISCO IOS router, configure the mapping of a host name to an IPv6 address as follows: None 16 bits Phenomenon analysis: This environment is not the same as before. First, the multicast data from R3 to Loopback0 port, then the First-hop router becomes R3 , instead of R2 a. Then R3 is the first hop router. After receivingthe multicast data sent by themulticast source (that is, its own LO0 ), R3 will trigger the Register process.The details of the register process are very familiar to everyone. winded, the end result is, R3 to R1 construct a SPF , from the reason that R3 Loopback0 port, sent to a multicast group FF04 :: 1 may be multicast data along the route R2 to R1 of SPF forward.