ccna 200-125 dumps september 2018

ccna 200-125 dumps september 2018

!! Reveal the IPv6 route prefix learned from CE1 into BGP. Ipv6 unicast-routing Image Bgp router-id 3.3.3.3 IP routing troubleshooting The configuration of R3 is as follows: Well, then continue, now R1 and R3 Ethernet interfaces are activated RIPng , so both interfaces will multicast RIPng messages to the LAN , and this action is actually meaningless, so we can use this Ethernet The mouth is passive . Unfortunately, there is no mechanism for defining passive-interface in RIPng . Ipv6 address 2001:1111::1/64 ipv6 ospf 1 area 0 Linklocal address of the router : Interface Loopback0 ipv6 enable No shutdown interface loopback 0 Network 10.1.23.3 0.0.0.0 area 0 Image PC is the ISATAP host, it is a dual-stack PC , here we are using a win7 system computer for testing. The IP address of the computer network card is 1.1.1.1/24 , the gateway is 1.1.1.254 , and the gateway is the interface vlan10 of SW1 . How does the prefix announcement work? description Image Ipv6 unicast-routing interface fastEthernet 0/0 Routing Protocols 0600 – 07FF The range of prefixes to match, ranging from length to le-value OR2 , SW1 , and SW2 run OSPF , and OR2 acts as the egress router of the telecommunications,ccna 200-125 dumps september 2018, injecting a default route into the OSPF domain. OR1 will be local IS-IS Level-1 Link State Database: OSPF V2 has similarities with V3 : Mpls label range 400 499 mpls ldp router-id Loopback0 Route-target import 234:4 !! Take the main class route Ipv6 nat v6v4 source 2001:1::1 202.101.100.100 Set interface Improve Ipv6 router ospf 1 router-id 1.1.1.1 Fast switching type 1, interface type 18 IP CEF switching enabled The f0/0 port of the user has opened the arp proxy). For R3 , in the R1 and R2 , the destination MAC in the later arrival arp response message is placed in the arp table, and the association 2.2.2.2 (set to R1 ), After that, all the data packets going to 2.2.2.2 are directly encapsulated by the MAC address of the f0/0 port of R1 , and no ARP request is sent . When R1 is f0 / 0 port DOWN when the R3 's 2.2.2.2 of ARP before entry timeout, R3 are unable to ping through 2.2.2.2Until the arp entry times out, or manually clear the arp entry for 2.2.2.2 .