ccna dumps may 2019

ccna dumps may 2019

Ipv6 address autoconfig [default] 1/128 Router(config-router)#redistribute ? Router(config-router)# passive-interface default Router(config-router)# no passive-interface int- type int-num Prefix-delegation pool dhcppool lifetime 1800 600 Tag 1111, type extern 2, forward metric 64 Ip address 202.101.23.3 255.255.255.0 None The configuration of R2 is as follows: Image Image Because when actually deployed, SVI mouth may be more,ccna dumps may 2019, go to if one of the no passive-interface to configure the amount may be relatively large, so you can choose to passive-interface defaut all interfaces of all passive off, and then a single interface to no passive -interface . FlowLabel : Flow Label, for QoS Tag information set local tag: 100 NDP can help us achieve the following features: Image (interface) ip load-sharing per-destination Ipv6 prefix-list test seq 5 permit 2001:3::/64 Ipv6 router rip RIPprocess This is because ip default-network is classful , so if you use this command to mark a subnet of a main class network, the router will actually install the main class network route corresponding to the subnet into the routing table without any deficiency. Provincial routing. So at this time, on the basis of the above, since the route of 172.16.0.0 is generated , the ip default-network command can be used again.