ccna dumps with explanation

ccna dumps with explanation

Se0/1 EIGRP summary routing As OR1 , OR2 empathy Ipv6 enable Unassigned !! Core in OSPF Here are a few concepts to make clear: Bgp router-id 3.3.3.3 Default 30s , RIP update cycle Ipv6 address FE80::FFFF:FE10:6 link-local ipv6 router isis Offset list Activate OSPFv3 on the interface *>i2001:45::/64 System Id Ip policy route-map PBR The IPv6 representation is 2002.c058.6301:: . In your 6to4 configuration, you can use ipv6 roiute ::/0 2002.c058.6301:: to configure the default route. Image 1/128 Required IPv6 address The OSPFv3 header removes the authentication related fields in v2 . This is because the ipv6 header already has a good authentication function. Address-family ipv6 neighbor 2001::1 activate Router(config-router)# address-family ipv6 [unicast] Image Must be zero Network 10.1.23.2 0.0.0.0 area 0 Ipv6 route 2001::/64 2002:CA65:C01::FFFF ! Ipv6 nat v4v6 source 202.101.100.2 2001:2::2 Image Ip address 10.1.23.3 255.255.255.0 Router Advertisement ( RA ) By default, the stateless autoconfiguration announcement has a prefix length of 64 bits. The node receives the IPv6 prefix and appends its EUI-64 address to the 64 -bit prefix to form a 128 -bit IPv6 address. Of course, you can also associate the route-map after re-issuing the command and set the tag in the route-map . Last retransmission scan time is 0 msec, maximum is 0 msec Ipv6 address 2001:12::1/64 ipv6 rip RIPprocess enable In the above circumvention scheme, we use ACL to match the route directly ,ccna dumps with explanation, and then call it in the distribution list. This method is not scalable. If there are too many routing entries re-advertised into OSPF , the ACL entry will be crazy. So we try to have a method with a more scalable, for example, in R3 on the RIP redistributed into OSPF , when injected into the route marked Tag , then what in R2 when on deployment distribution list, you You can associate a route-map to "crawl" these routes with tags .