ccna new dumps

ccna new dumps

Management distance problem Interface FastEthernet1/0 Cc01.0cf0.0000 Ipv6 address 2001:1::FFFF/64 ipv6 nat The TAG value is set when the originating ASBR generates an external LSA . If the external LSA is re-advertised to other OSPF autonomous systems, the TAG value is carried by default. ! Router(config-if)# ipv6 ospf process-id area area-id RIP-1 Only The configuration of PE2 is as follows: Stateless autoconfiguration 192.168.2.0/24 Image Ipv6 ospf 100 area 2 127.0.0.1 localhost Set ip next-hop verify-availability 10.2.2.2 20 track 2 Must be zero We finally do another test,ccna new dumps, that is, the ISATAP host pings 2008: 8888::1 . The configuration of R2 is as follows: Image ! Interface FastEthernet1/0 None Interface tunnel 0 Image Image Set interface specifies how to send such a packet set ip default next-hop specifies the next hop to be forwarded set ip next-hop specifies the next hop to forward Tunnel mode ipv6ip 14 packets, 7640 bytes Image Image Image Image The configuration of R3 is as follows: No bgp default ipv4-unicast neighbor 2001::1 remote-as 12 Ipv6 address 2002::1/64 ipv6 enable The vocation of the router is to maintain the routing table and use the routing table for data forwarding. The routing table contains routing entries or routing entries learned through various channels. The simplest and most straightforward method is to use static manual configuration to create routing entries for the router. This method is the most direct and controllable. The highest, the most simple configuration. In a small network, there seems to be no problem with static routing on the whole network. However, in a large network, if you use static routes purely, the workload is very large, not only the workload is large, but another more important defect is Static routes cannot be adjusted according to changes in network topology. Therefore, in large-scale networks, we often use static + dynamic routing protocols to complete route deployment.