ccna latest dumps 200-125

ccna latest dumps 200-125

Exit-address-family 10.1.13.3 X !! Define the Ipv6 prefix to prepare for the announcement R2 Interface FastEthernet0/0 Verify the role of the match interface 2 In R2 opened on loopback interfaces 2.2.2.0/24 , R2 both redistributed RIP into OSPF , they redistribute directly connected into OSPF Ipv6 address 2001:8888::8/64 8 : organization scope; In fact, there are two main lifetimes of IPv6 addresses , one is Valid lifetime and the other is preferred lifetime . First in When a node starts the IPv6 protocol stack, each interface of the node automatically configures a link-local address. This mechanism allows two IPv6 nodes connected to the same link to communicate without any configuration. The default gateway recommends using a link-local address because this address is the most stable. 1000 – 1FFF Ipv6 route 2002::/16 Tunnel0 External BGP Ipv6 nat Route, and redistribute the route into its own OSPF process 2 , then R3 will learn this route from process 2 , assuming R3 learns this first Image Route-map OSPF3to2 permit 20 match tag 20 No bgp default ipv4-unicast neighbor 2001::1 remote-as 12 The above is the address that the host node must have. The router is different. The following addresses are added: All routers have multicast addresses: FF01::2 ; FF02::2 ; FF05::2 Image 10.1.31.0/24 This subnet has been successfully updated " 10.1.31.0 " because it is the same as the main source of the R1 update source interface . Last retransmission scan length is 0, maximum is 0 Ipv6 ospf 1 area 0 Ipv6 address 2002:CA65:1703 ::FFFF/64 ipv6 enable RIP-2 Only RFC1722 Ip address 10.1.23.3 255.255.255.0 Ipv6 address 2001:5555::5/128 interface FastEthernet0/0 Router isis Ipv6 dhcp server DHCP-pool !! Enable ipv6 DHCP on the interface and call the pool !! Sends a distribution update action to a RIPng interface to perform a distribution list. The interface must be in the in/out direction. The interface is optional. If no interface is configured, the interface takes effect. Image Neighbor FE80::CE01:8FF:FED8:10 update-source FastEthernet0/0 At infinite When a node starts the IPv6 protocol stack, each interface of the node automatically configures a link-local address. This mechanism allows two IPv6 nodes connected to the same link to communicate without any configuration. The default gateway recommends using a link-local address because this address is the most stable. Image None IPv6 Address(es): FE80::FFFF:FE10:4 ! Pop tag Image ! Image Ip sla monitor schedule 1 life forever start-time now Ipv6 nat Total length of Total Length; Target Options Header (Protocol 60 ) !! define vrf Test description: ping FF04::1 on R2 , Fa0/0 on the outbound interface UDP RIP Version 2 Protocol Applicability Statement The NIC is configured with an IP address of 1.1.1.1/24 and the gateway is 1.1.1.54. * 0x0000000B Address format: FF02:0:0:0:0:1:FFXX:XXXX , the specific correspondence is as follows: NDP Neighbor Discovery Protocol ( RFC2461 ) Unassigned Next, we R3 up of ping 2222 :: 2 , this action will cause the R3 transmits an ICMPv6 packet, source 2000: 123 :: 3 , the purpose of 2222 :: 2 , the packet will be sent to R1 , when R1 After receiving, he found that the packet will be forwarded from the interface that received the packet,ccna latest dumps 200-125, and the next hop IP is on the same network segment as the interface, proving that the next hop is better than itself (distance from the destination) closer).