ccna dumps with answers

ccna dumps with answers

Foundation ! Rhino.acme.com When the link between R1 and R3 fails, the same network will still have problems. Because R2 re-releases the locally configured static summary route into the Difficult analysis Image 3 204/nolabel Image Now, change the interface ipv6 MTU of the F1/0 port of R2 to 1400 bytes (the default interface IPv6 MTU in the above figure is 1500 bytes): 8 : organization scope; Image Image TCP Set metric 2 !! Change the metric to 2 The router queries through recursion, the next hop 2002: CA65:1703::FFFF should be thrown to tunnel0 , and tunnel0 is a 6to4 tunnel, so the 2002:CA65:1703::FFFF is translated into the corresponding V4 address,ccna dumps with answers, which is 202.101.23.3 Interface Loopback0 The PC will start sending RS with the following message: Image ! Image The update is sent. At this time, both parties have their own routes, but 1.1.1.1 cannot ping with 2.2.2.2 . Router(config-rtr)# timers update expire holddown garbage-collect ! Device automatically, without human intervention, the interface of the MAC to obtain address conversion 64bits the EUI-64 format of the interface ID process are as follows: 134 AFI (Address family identifier) Ipv6 route ::/0 tunnel 0 Let's look at the picture and deploy a two-way re-release on R2 and R3 . The configuration of PE1 is as follows: Bgp router-id 2.2.2.2 Basic knowledge After the command is configured, the neighbor R2 receives the prefix and displays the following: R2#sh ipv int f 0/0 You should know that each routing protocol has different understandings of routing metric metrics . OSPF uses cost overhead to measure a route, RIP uses hops, and EIGRP uses mixed elements, so when I Some routes, from one of the routing protocols to another routing protocol, how will the metrics of these routes change? One way is that you can manually modify the re-release action when you perform the re-release action, depending on the specific environmental requirements, we will not worry about this later, the buddy is so sincere :). The second way is to use the default action, which is the seed metric defined when republishing between routing protocols.