ccna dumps pdf

ccna dumps pdf

Access-list 2 permit 2.2.2.0 Access-list 1 permit 1.1.1.0 Duplicate address detection ( DAD ) Route-map nat2 permit 10 match ip address 1 Do not use prefix for onlink determination Image Interface FastEthernet1/0 Route-map overview Ipv6 nd ra-lifetime If the local end has this feature enabled, the next-hop device does not support CDP , then switch to the next next-hop . If there is no next-hop , skip the PBR. The new routing table is typically sent to neighboring routers on a regular basis, and the triggered update is sent immediately in response to changes in the routing table. Ipv6 address 2012::2/64 ipv6 nd suppress-ra R1(config)# interface fast0/0 R1(config-if)# ipv6 enable Ipv6 router rip RIPprocess 100x xxxx xxxx xxxx Becomes 24 bits,ccna dumps pdf, appears in HELLO package, DBD package, and router LSA , network LSA , interAreaRouter LSA , Link LSA 10.1.13.3 Interface tunnel1 Ipv6 enable !! GW has no other configuration about routing ipv6 rip RIPprocess enable !! activates the RIP Interface fast1 / 0 The initial situation is the same as above. Let's take a look at redistributing OSPF routes into EIGRP AS 100. The configuration is of course still carried out on R2 . Ipv6 address 2012::2/64 ipv6 nd suppress-ra Ipv6 address 2001:1111::1/64 ipv6 ospf 1 area 0 Image Multilink Multilink-group interface Ip address 2.2.2.254 255.255.255.0 Interface ID: After ISATAP is enabled on the host, an ISATAP virtual network card is generated. The virtual network card generates a 64- bit special interface identifier, which is similar to EUI-64 . However, the mechanism is different. It isreserved by 32 bitsreservedfor ISATAP .The 0200:5EFE is combined with the IPv4 address configuredon the host.As shown in the following figure, ifthe IPv4 addressconfigured by the ISATAP hostis 1.1.1.