ccna 200-125 dumps testking

ccna 200-125 dumps testking

Neighbor status tracking GW configuration Image IPv6 Address(es): FE80::FFFF:FE10:4 Passive interface R 1.1.1.0/24 is possibly down, Subnet Mask NS 135 Ipv6 router ospf 100 router-id 2.2.2.2 FastEthernet0/0 Neighbor 2.2.2.2 send-label Interface tunnel1 Ipv6 enable (2) Declare the loop port 1.1.1.1224 Rhino.acme.com Border Gateway Protocol (BGP) Connected Ipv6 prefix-list test seq 5 permit 2001:3::/64 Ipv6 router rip RIPprocess R1(config-if)#ipv6 nd prefix 2001::/64 ? Ip address 192.168.10.254 255.255.255.0 Set local-preference set weight IPv6 interface address: This TLV contains an IPv6 interface address ( 128bits ). The decimal value assigned to the IPv6 interface address TLV is 232. For IS HELLO PDUs , this TLV must contain the Linklocal address, but for LSPs , the TLV must contain a non- Linklocal address. Image Ipv6 address 2001:23::2/64 The configuration of R1 is as follows: 850 Image So when R1 sends a big packet to R4 , there will be no problem. This is fragmented directly at the source of R1 . Of course, we can continue to experiment, set the IPv6 MTU to 1300 bytes on the Fa1/0 interface of R3 , and then continue R1 to ping the big packet to R4 ,ccna 200-125 dumps testking, and finally the cache entry on R1 . compatibility Image Static NAT-PT (one-way) None Port-channel Ethernet Channel of interfaces View the interface (network card, including virtual network card) index and name, equivalent to ipv6 if x under WindowsXP FastEthernet1/0 Image Because RIP appeared earlier, early routers used serial link interconnection (point-to-point links), so RIP triggered updates only supported on point-to-point links, for Frame-Relay and Ethernet. In the multi-access interface, RIP trigger update is not supported , but the Frame-Relay point -to- point sub-interface is considered by RIP to be a point-to-point link, and the trigger update can be enabled.