ccna 200-125 dumps pdf 2018

ccna 200-125 dumps pdf 2018

Tag 1111, type extern 2, forward metric 64 Image Image No frame-relay inverse-arp ipv6 enable OSPF and BGP Image Y Label associated with the VPNV6 prefix: R1 Neighbor FE80::CE01:8FF:FED8:10 remote-as 12 neighbor FE80::CE01:8FF:FED8:10 password cisco Redistribute connected level-1 exit-address-family Note that the above is the default metric when re-publishing from other dynamic routing protocols into this routing protocol . If you republish a local direct connection or a static route, the situation changes, as follows: RIP V1 supports a maximum of 6 and defaults to 4 equivalent load balancing. And does not support verification. V2 supports verification. Ipv6 unicast-routing interface fastEthernet 0/0 Route summary R1(config-if)# ipv6 address 2001:0001::/64 eui-64 R1 goes to ping R4 and can ping . The PC will start sending RS with the following message: Access-list 1 permit 10.1.1.0 In R2 opened on loopback interfaces 2.2.2.0/24 , R2 both redistributed RIP into OSPF , they redistribute directly connected into OSPF If the feature is not enabled on the local end, the data packet is either routed successfully or never routed out (discarded). IPv6 Address(es): FE80::FFFF:FE10:1 RFC1722 DHCPserver configuration ::FFFF:4.4.4.4 (metric 3) from 4.4.4.4 (4.4.4.4) Initially, R3 can learn three loopback routes from R1 and 192.168.12.0/24 routes. Now we don't want R3 to learn the route to 192.168.3.0/24 , then we can configure it on R2 as follows: First, all routers in the site continue to advertise the current prefix (old prefix), but the valid and preferred lifetime are reduced to a value close to 0 ,ccna 200-125 dumps pdf 2018, then the router starts advertising new prefixes on the local link, so each local There are at least two prefixes on the link. When the old prefix is ​​completely retired (the lifetime has passed), the router advertisement message only includes the new prefix.