ccna 200-125 dumps forum

ccna 200-125 dumps forum

Match ip address 1 set metric 10 OSPFv3 uses the IPv6 Linklocal address to identify OSPFv3 neighbors. ? MAC address mapping for IPv6 multicast addresses After R3 receives this ICMPv6 redirect message, subsequent packets will be sent directly to R2 , so there is no need to bypass R1 . ! Reserved unspecified,ccna 200-125 dumps forum, loopback, IPv4 compatible address Ipv6 router isis ISATAP tunnel Experiment 1 !! Since Fa0 / 0 connected to a router rather than the host, to reduce unnecessary ra of Image In R1 , R2 at each hanging two IPv6 islands, now, by R1 and R2 establish a room IPv6 over IP of Tunnel , so that the two IPv6 islands to cross the IPv4 Internet and interconnected. In front of the original IPv6 packet, the IPv4 of the previous tunnel was added. Ipv6 router ospf 100 router-id 3.3.3.3 exit Ip route 10.1.2.0 255.255.255.0 10.1.254.1 By default, the stateless autoconfiguration announcement has a prefix length of 64 bits. The node receives the IPv6 prefix and appends its EUI-64 address to the 64 -bit prefix to form a 128 -bit IPv6 address. Ipv6 address 2001:1111::/64 eui-64 no ipv6 nd suppress-ra When both the primary and secondary addresses are present, the RIPV1 router will use the mask of the secondary address of the interface that receives the route update packet locally (this has been verified in the above experiment). Timers Image R4 released the RIP route of 100.1.1.0/24 , which can be learned by both ASBRs . The solution is to configure static summary routes on the two ASBRs : length NAT (Network Address Translation) 8 10.1.12.2 !! Ping link local address and site local address may need to add index number, ping global unicast Test phenomenon: can ping through Now, we have to draw a vertical line, the left side of this line, the binary number of each column is the same, the right side of the line does not matter, can be changed, pay attention to this vertical line, you can hide from the default The length of the code, that is, the beginning of /24 , moves to the left in a grid until you observe that the value of each column on the left end of the line is equal, you can stop. At this time, the position of the line is just right. .