ccna 200-125 dumps examcollection

ccna 200-125 dumps examcollection

In the process of double-point bidirectional routing re-release, many problems may occur, such as sub-optimal paths, potential routing loops, etc. This chapter will discuss this model and existing problems in depth. The configuration of R2 is as follows: R1#show ipv6 ospf neighbor detail PE1#show bgp ipv6 unicast Image Ipv6 nat prefix 2001:2::/96 Tag rewrite with Fa1/0, 10.1.13.3,ccna 200-125 dumps examcollection, tags imposed: {} via 10.1.12.2, FastEthernet0/0, 0 dependencies The configuration of R1 is as follows: Options is 0x6423B8FD Dead timer due in 00:00:31 Neighbor is up for 00:05:46 Ipv6 address 2004::4/64 NAT-PT#show ipv nat translations None ! Router bgp 300 !! ipv6 routing, all traffic to the IPv6 network is thrown into the tunnel Interface vlan 20 Unassigned Ip sla monitor 2 The notification interval of the RA message, which is less than or equal to ra-lifetime . The default is 200S . Image The configuration of R1 is as follows: OE2 2004:1:2::/64 [110/20] As a result, on R2 , the OSPF route 1.1.1.0 in the routing table and the 192.168.12.0 directly connected network segment that is declared into the OSPF process are all announced to RIP , and R1 can learn the two routes through RIP. , as shown in the red bold part below. Neighbor 4.4.4.4 send-community extended exit-address-family 2000::/3 (2000:: to 3FFF::) is an aggregatable global unicast address space. // in R3 is only 1.1.1.0 route, that distribute-list 1 out here this command, all externally injected into the 6to4 automatic tunnel configuration Ipv6 address 2001:45::4/64 ipv6 ospf 1 area 0 MTU is 1500 bytes Ipv6 address FE80::FFFF:FE10:1 link-local 137 !! Construct an Ipv6 address using the EUI64 address; Set ip next-hop 22.2.2.2 Image Next Hop Interface FastEthernet0/0 Application layer gateway ALG 1 URL representation of the IPv6 address After the above configuration, when the user in the IPv6 island connected to R1 wants to access other 6to4 networks, then R1 obtains the IPv4 public network IP from the destination 6to4 IPv6 address , and then forwards the tunnel IPv4 data packet to the destination 6to4 router.