200-125 exam dumps

200-125 exam dumps

Route-map test permit/deny 20 2002 : IPv4 address : Subnet ID : The IPv4 address above the interface ID is the public network IPv4 address obtained by A or B. Note that this public network IP is very important. This public network IP change may lead to IPv6. Intranet IPv6 had to be readdressed. And, of course,200-125 exam dumps, this IPv4 address cannot use a private IPv4 address. This way the routing table: If the outbound interface is a broadcast interface, it may impose an additional burden ( ARP ) on the nodes under the interface or cause potential problems. Interface FastEthernet1/0 ipv6 ospf 1 area 0 Area Address(es): 49.0001 SNPA: *HDLC* Ipv6 enable The notification interval of the RA message, which is less than or equal to ra-lifetime . The default is 200S . 100 Allocation This is a simple method of data offloading and path redundancy using the longest matching principle. Image ! FastEthernet0/0 is up, line protocol is up Ipv6 route ::/0 tunnel 0 Incomplete Reachable Stale Delay The thing we have to do is very simple. These subnets are continuous. It is enough to pick out the first two or three network numbers to calculate: Image Associate route-map when route is republished (typical case) Prefix readdressing When ISP1 is down, the interface of GW connected to ISP1 is DOWN , and the traffic of PC access 100 is automatically switched to ISP2. Configure all interfaces as passive and manually activate specific interfaces: No bgp default ipv4-unicast bgp log-neighbor-changes neighbor 2001::1 remote-as 12 Image Identify the type of message: R2(config)# access-list 1 deny 192.168.3.0 R2(config)# access-list 1 permit any R2(config)# router ospf 1 Image PMTUD Ipv6 route 2222::/64 FastEthernet0/0 FE80::CE00:1AFF:FEE4:0 Packet-based load balancing and process switching. Process exchange is for each packet , the router must perform routing table query and interface selection , and then query the data link information. Because each process that determines the routing of packets is independent of each other , all packets destined for the same target network are not forced to use the same interface. In order to open the process exchange function on the interface , you can use the command no ip route-cache under the interface . For IPv6 nothing needs to be done , because by default the feature is turned on.