ccnp tshoot chapter 2

ccnp tshoot chapter 2

Ip arp inspection log-buffer entries number 201 200 BPDUFilter Neighbor table SW2(config-if)# glbp 1 10.1.1.254 The IP header is 20 bytes, the ICMP header is 8 bytes, and the ICMP data payload is 1472 bytes, which is exactly 1500 bytes. Therefore, on the CISCO IOS device, the size followed by the ping refers to the entire size of the outgoing IP packet. Router(config-dhcp)#default-router [host address] ( Well-known mandatory ) The Protected port feature cannot be configured across switches: Routing Information Protocol (RIP) The set statement cannot be included in the Policy-list , but after it is called by route-map , the route-map can contain the set statement. Configure the SVI interface corresponding to the VLAN . Non-default (manually configured non-default) priority and cost unchanged After completing the above steps, the logical etherchannel interface is set up. The configuration of R3 is as follows: Route . 3 : the AS_PATH : 500 the MED : 150 External RouterID : 172.16.13.1 5.5.5.5 10.1.13.1 Gateway of last resort is 172.16.3.0 to network 172.16.0.0 The router is typically used to determine whether the inbound interface and the source and destination address type CEF exchange . For consider CEF of routers , the outbound interface must be configured to CEF exchange mode , if the interface is configured CEF, then CEF will attempt to exchange data package. Otherwise , CEF will deliver the packet to the next best available exchange method. COMMUNITY Neighbor 10.1.13.3 remote-as 345 neighbor 10.1.13.3 route-map test out no auto-summary Match ip address prefix-list 11 set as-path prepend 600 Ip sla monitor 2 Ip community-list 11 permit 100:11 Ip arp inspection validate { [dst-mac] [ip] [src-mac] } This port type defined by RSTP is very similar to Portfast . Because these interfaces are used to connect to the host,ccnp tshoot chapter 2, loops are generally not generated. These ports can skip the LST or LRN to directly transition to the forwarding state. And when these interfaces are up , they will not cause topology changes. In addition, once the edge port receives the BPDU , it immediately loses the feature of the edge port and becomes a normal spanning-tree interface.