ninetut ccnp tshoot

ninetut ccnp tshoot

Multiplication character Ip address 10.1.34.3 255.255.255.0 Add the following configuration on R3 : version Match ip address 1 set metric 10 When the number of prefixes received from the neighbor exceeds the maximum number 300 of 90% (default 75% ), generating a message log DHCP relay TYPE Community number in aa:nn format Add to the existing community Metric A policy-list is like a route-map that only contains a match statement. Because when actually deployed, SVI mouth may be more, go to if one of the no passive-interface to configure the amount may be relatively large, so you can choose to passive-interface defaut all interfaces of all passive off, and then a single interface to no passive -interface . State BGP current callback state is basically opensent, etc., admin indicates that the neighbor is managed-type shutdown , when ? The greater the weight , the more priority If there are no dynamic and static routes on R2 , and the configuration is as follows: 8 bits 300 | Path Le keyword is not written, then the default is greater than 24 less than 32 Based on UDP protocol ports 67 and 68 Defaut-network takes precedence and becomes the default gateway gateway of last resort . However, if the network specified by ip defaut-network is learned from a dynamic routing protocol, ip route 0/0 takes precedence. In this way, the entire network is interconnected. Note that when redistributing routes to OSPF , redistribute rip subnets ,ninetut ccnp tshoot, this subnets The vocation of the router is to maintain the routing table and use the routing table for data forwarding. The routing table contains routing entries or routing entries learned through various channels. The simplest and most straightforward method is to use static manual configuration to create routing entries for the router. This method is the most direct and controllable. The highest, the most simple configuration. In a small network, there seems to be no problem with static routing on the whole network. However, in a large network, if you use static routes purely, the workload is very large, not only the workload is large, but another more important defect is Static routes cannot be adjusted according to changes in network topology. Therefore, in large-scale networks, we often use static + dynamic routing protocols to complete route deployment.