ccnp route exam answers

ccnp route exam answers

2 : 1 to 3 For the interface in the forwarding and listening state, transition to the block state (in the case of link failure) PAgP mode: Route Control Overview 77 Neighbor 4.4.4.4 update-source Loopback0 neighbor 10.1.25.2 remote-as 200 Network 30.30.30.0 mask 255.255.255.0 If the route is imported using the aggregate-address command, the MED is empty. 0.0.0.0 OK Match ip address prefix-list 1 set weight 100 R1 and R2 establish EBGP . On R1 , the network announces 11 and 12 network segments. To filter out 12 network segments, do not let them pass to R2 . SW3 immediately aging the BPDU stored on Fa0/3 , and port Fa0/3 enters the listening state and starts to send BPDUs. Adjacency table NEXT_HOP to 10.1.123.2 , then if C is not on the router to the IP of PVC , will be a problem, so this should be taken into account. OSPF and BGP We restore the experimental environment to the basic configuration: BGP neighbor relationships are as follows The configuration on R3 is as follows: Deployment points 32 bits If it is injected through the aggregate-address command, next-hop is equal to the update source IP of the summary router . The address family message is always 2 by default , and is 0 when requesting the entire routing table. Figure 2 R1 and R3 are the same AS , and the route of the 13 network segment is updated to R2 at the same time . The experimental effect is also in accordance with the rule description. If it is in the IBGP environment, that is, R1 , R2 , and R3 are all in one AS , then the rule Rules do not apply [abcd] AFI (Address family identifier) The frame to which the Native VLAN belongs is not tagged when it passes the trunk . 100 When ISP1 is down, and the GW does not detect it (that is , the interface of GW connected to ISP1 is not DOWN ), the traffic of PC access 100 is still thrown to ISP1 ,ccnp route exam answers, which is disconnected. 16 bits Vlan 10 For the next hop and route tag, see Volume I, page 189 . 1-4094 BGP router identifier 3.3.3.3, local AS number 345 BGP table version is 1, main routing table version 1 Sw(config)#interface range fa 0/3-4 Holddown timer expired Configuring a VTP domain name If the interface is configured as a host interface Discard (that is , the combination of disabling, blocking, and listening in 802.1D ) Access-list 2 permit 192.168.2.0 0.0.0.255 route-map PBR permit 10 After Port-Security is activated on the interface , the interface has certain security functions, such as limiting the maximum number of MACs of the interface (connected) , thereby limiting the access host users; or limiting the specific MAC to which the interface is connected . Thereby achieving the restriction of accessing users. Then to perform filtering or limiting actions, you need to have a basis, which is based on the secure address – secure MAC address .