ccnp switch lab questions

ccnp switch lab questions

The default load balancing method is round-robin Sw(config-vlan)#private-vlan community To this end, some organizations and manufacturers propose to layer the data link layer, which is divided into logical link control sub-layer ( LLC ) and media access control sub-layer ( MAC ). Such different physical layers correspond to different MAC sublayers, and the LLC sublayer can be completely independent. As shown in Figure 1-4 . RIP version number: By AS_PATH influence route selection 90 The next outgoing interface of the route is the port of the match . 9.9.23.0 is directly connected, FastEthernet0/0 Ip community-list 11 permit 100:11 * i100.0.1.0/24 In the port field of the circuit-ID suboption, the port numbers start at 3. That is to say, in this field, the port number is from 3 , the first port number is 3 , and so on. For example, a 24- port switch with an SFP slot , port3 is fast x/0/1 , port4 is fast x/0/2 , and so on, port 27 is the x/0/1 port of the sfq module . Where x is the stack member number. SW2 is the core layer switch, deploying DHCP relay VLAN Interface For details on the related fields of the BGP table, see the show section of the BGP Configuration section of this document. The main routing table version is injected into the last table version in the main routing table. At the same time,ccnp switch lab questions, the two routes are marked in the BGP table: " *> ", indicating that the two routes are valid , and the best or optimal, best , so they will be passed to the IBGP neighbor of R3 . That is R4 Ip address 10.1.25.2 255.255.255.0 Since R4 and R5 are federated EBGP , there are also TTL problems, so if they use LOOPBACK to establish neighbor relationships, you should pay attention to setting ebgp-multihop . *> 100.0.1.0/24 Neighbor 5.5.5.5 ebgp-multihop 3 Access-list 1 permit 1.1.1.0 5.5.5.5 Router bgp 300 Let us look at the above example. In a typical education park network, we often have more than two external network export routes, assuming one for telecommunications and one for education network. Then we generally add a default route to the egress router, pointing to the next hop address of the telecom, in order to allow intranet users to access Internet resources through telecommunication lines . However, if the telecommunications export fails? We can add a default route to the router.