how to pass ccnp switch

how to pass ccnp switch

None Path Control Overview 300 (Note that in the actual environment, the situation may be quite different). Second column > Optimal path selected by BGP algorithm For details on the BGP neighbor table field,how to pass ccnp switch, see the show section of the BGP Configuration section of this document. Forward Route-map test permit 20 router bgp 200 None Passive interface This environment is relatively simple, PC and DHCP server in the same VLAN , I mainly want to confirm that the ordinary switch pair is carried _ On R4 , there are also redundant links to 100.0.1.0 and 2.0. Both R3 and R5 can reach the two network segments, and finally R4 selects R3 as the next hop to the two network segments. Because in the BGP routing principle, the route preference decision is compared to the BGP routerID , and the RouterID of R3 is smaller than R5 , so R4 is preferably R3 . None ? After the command is configured on the interface, the routing table is not updated periodically in this direction, but the update is triggered. The routing table update will be minimal , including only the initial exchange information of the routing table and the updated information when the routing table changes. This command is only valid on the serial link and must be configured at both ends of the link to produce an effect.