how much is ccnp switch exam cost

how much is ccnp switch exam cost

Fa0/20 Note that, EIGRP the metric is a mixed type, metric. 1 100000 100 255 1500 Parameters specified here, from left to right is the bandwidth, delay, load, reliability, the MTU . It can be flexibly set according to actual needs. After the above configuration is completed, R2 will be in the routing table. Weight 8 bits Router bgp 64512 no synchronization no auto-summary Ip prefix-list 1 permit 11.11.11.0/24 ip prefix-list 2 permit 12.12.12.0/24 route-map RP1 permit 10 By default, only the MED values of BGP routes from the same neighbor AS are compared , that is, if the two routes of the same destination are from different ASs , the MED value comparison is not performed . MED only affects the traffic between directly connected autonomous systems, and does not pass through the AS . The smaller the MED, the higher the priority. The route to the LOOPBACK interface. Address-family ipv4 unicast Ip route 0.0.0.0 0.0.0.0 192.168.23.3 * 172.16.0.0/16 is variably subnetted, 4 subnets, 2 masks S* 172.16.0.0/16 [1/0] via 172.16.3.0 Select the port for the Channel 3.3.3.3 BVI Bridge-Group Virtual Interface When ISP1 when down, and GW connected ISP1 interface not DOWN (such as closing ISP1 the CDP ), since the GW lost ISP1 of CDP Router bgp 64512 After the Port-Security feature of an interface is activated,how much is ccnp switch exam cost, the default maximum number of secure addresses is 1 , that is, the interface uses its dynamically learned MAC address as a secure address without manually configuring a secure address. This interface is equivalent to being exclusive to the MAC (the device to which it belongs). And the default violation is shutdown Match ip address Virtual-PPP Virtual PPP interface Looking at the above picture, we assume that both switches A and B run DAI , and both PC1 and PC2 get the address through the DHCP server. At this time, for PC1 , only the DHCP snooping database on switch A has its IP+MAC . Bind, switch B does not. Thus, if A and B interfaces between the DAI the untust , from the PC1 of ARP packets, the switch will be B discarded, because it is believed these are illegal packets, this way, PC1 and 2 communications on the problem It is. It is recommended that A and B interfaces are provided between the DAI ofTrust .