ccnp route workbook pdf

ccnp route workbook pdf

Use the err-disable command to modify the duration of the err-diasable state. The default is 300S. The comparison principle of OE2 is first compared to the external metric of OE2 . If they are equal, further comparison of the internal metric is the metric to the ASBR . The configuration on R3 is as follows Routing policy 50 If the ibgp keyword is not associated , only EBGP routes will be equivalently load balanced (by default only for EBGP routes). If maximum-paths is not configured , the next routing principle will be followed. The configuration of SW2 is as follows: Detailed rules Access-list 1 permit any route-map PBR permit 10 match ip address 1 Port-channel Ethernet Channel of interfaces Network AS_PATH , and AS_PATH only when routing out this AS or BGP routers to update EBGP will change when neighbors in AS inside will not change, therefore, in the AS internal,ccnp route workbook pdf, anti-ring requires the use of split horizon. So how to solve the problem that R5 ca n't learn routing? Hello time 3 sec, hold time 10 sec Next hello sent in 1.280 secs The smaller the MED, the higher the priority Configure BPDUs Route-map If both commands are closed: Network 100.0.2.0 mask 255.255.255.0 neighbor 10.1.25.5 route-map test out RSTP is able to quickly transition between edge ports and point2piont links. The link type of the RSTP is automatically obtained through the duplex state of the interface. If the interface is half-duplex, the link type is the shared port . If it is full-duplex, it is point2point . Switch(config)# ip default-gateway 192.168.255.254 !! Set the gateway for the access switch itself If ip routing is enabled , the command is ignored (but the default route Ip route 0.0.0.0 0.0.0.0 x ) is displayed ; Origin file flash:CCIE.txt DAI configuration command R1 update source IP match, although the update source of R2 configuration is the default (packet outbound interface IP 10.1.12.2 ), but the BGP connection establishment between the two is no problem, because the connection of R1 to R2 is no problem. . At the same time, it is also possible to delve into the routing problem. For example, if R2 is localized to the 1.1.1.0 static route and is configured as the default route, we will find that the BGP connection can still be established, because R2 is the passive of the BGP connection in this example. who, R1 have specific routes to initiate connection. However, if the static static route from R1 to 2.2.2.0 is changed to the default, then it will not work, and R1 will consider " no route to peer ".