ccnp route jobs

ccnp route jobs

Example 1 : Neighbor 5.5.5.5 ebgp-multihop 3 Another problem with proxy ARP (from TCP/IP routing technology volume one) When the routing policy changes, the neighbor is requested to re-advertise the route ( BGP does not periodically send updates) After deploying DAI , we can define the trust status of the switch interface: trusted , or untrusted , for trusted ports, it will not be received. Ip route 100.1.0.0 255.255.0.0 null0 Maximum-paths 2 Configuration Then use set comm-list 1 delete to delete, pay attention to the above community-list writing, use multiple lines, the experimental verification results are in Then the NH of this BGP route is the interface IP of the announcer . EBGP neighbors generally use the other party's direct interface IP to refer to the neighbor . However, if the EBGP neighbor is established by using the LOOPBACK interface , the NH is the update source address of the EBGP neighbor. (Of course, the EBGP neighbor does not use the LOOPBACK interface to establish a neighbor.) Heavy FAQ published The vocation of the router is to maintain the routing table and use the routing table for data forwarding. The routing table contains routing entries or routing entries learned through various channels. The simplest and most straightforward method is to use static manual configuration to create routing entries for the router. This method is the most direct and controllable. The highest, the most simple configuration. In a small network, there seems to be no problem with static routing on the whole network. However, in a large network,ccnp route jobs, if you use static routes purely, the workload is very large, not only the workload is large, but another more important defect is Static routes cannot be adjusted according to changes in network topology. Therefore, in large-scale networks, we often use static + dynamic routing protocols to complete route deployment.