ccnp route chapter 4 exam answers

ccnp route chapter 4 exam answers

Activate Port-Security on the interface If a DHCP relay is also deployed on the switch, the switch adds the relay address to the DHCP packet. The packet is captured as follows ( R3 sends the BGP update package to R4 ): Network topology and interconnection IP address planning as shown Bgp bestpath med missing-as-worst Ip address 192.168.100.1 255.255.255.0 SW1(config-if)# glbp 1 load-balancing host-dependent !! The same PC (source MAC ) is assigned to a fixed gateway virtual MAC None | permit }} basic concept MAC address allocation and reduction Two-way re-release on R2 . Under normal circumstances, R1 can learn 3.3.3.0 , and R3 can learn 1.1.1.0. Type echo protocol ipIcmpEcho 10.1.1.2 source-ipaddr 10.1.1.1 frequency 10 R1 and R3 , R2, and R5 establish an EBGP neighbor relationship. Unicast update 53 Interface vlan 100 So looking at the above picture, two VLANs are created on the Layer 3 switch : 10 and 20 , and the addresses of the SVIs of the two VLANs are assigned as the user gateways of the respective VLANs , so that the routing table of the switch is There are routes for two VLAN segments. Then,ccnp route chapter 4 exam answers, when the two VLANs need to communicate with each other, the user of VLAN 10 will drop the data to his own gateway, that is , the SVI of VLAN 10. After the data arrives at SVI10 , the Layer 3 switch looks up the table and finds that the destination is the network segment where VLAN 20 is located. Throw the data out of VLAN 20 and eventually reach the destination VLAN 20 of the PC .