ccnp switch 6.0 instructor lab manual

ccnp switch 6.0 instructor lab manual

CCIE.txt format: 100 Interface loopback0 All devices complete the basic configuration and establish BGP neighbor relationships. The yellow area is the federated member AS . 200 In a route-map statement, if there is no match statement,ccnp switch 6.0 instructor lab manual, match all / / There is a S entry in the routing table Configuration example Router(config)# router ospf 1 Passive-interface Fa0/0 R4 and R2 , we look R2 , R2 moment from R4 has learned this RIP routes, if it from the R3 also learn the route and of the route metric is smaller, then, R2 will preferably from R3 this Routes , so that R1 , R2 , and R3 form a routing loop. Frame format //trunk package protocol is dot1q Preemption enabled, min delay 30 sec Note that this time you add the extend keyword in the send-community Static route configuration 20 Sw1(config)#interface range fastEthernet 0/1 – 2 // Enter interface range Sw1(config-if-range)#switchport // Configure the interface as a Layer 2 interface But there is a loop in the second floor environment. No off default route above configuration, adding a destined 13.0 network routing next hop is R3 , the PC to 13.0 data network switch to R3 proof ip default next-hop priority routing detail below, above Default route. Prefix-list 70 Kanga sends an arp request, requesting Milne 's mac , then Use CDP to detect next-hop IP reachability in PBR environment (without optional parameters) Route Control Overview 77 The configuration of R5 is as follows: In this mode, a data flow (Flow) in the first packet (Packet) will be placed into the cache system (system buffer). The destination address to the routing table will get a match query , the processing of the router device (CPU or Processer) while for CRC check , check whether the packet correctly . then Layer packet MAC address will be rewritten , replaced by the next-hop interface MAC address, this process will continue , for this data flow (flow) in the first 2 th, . 3 packets ...... same operation , comprising a routing table is rewritten MAC address , CRC checking. This method is undoubtedly the most delayed , because it uses the system buffer and processor to process each received packet .But we still have the opportunity to use this type of exchange , such as when performing load balancing based on each package , or when debugging ip packets .