ccnp switch workbook

ccnp switch workbook

Authentication is identified by setting the address family ID field to all 1s ( 0xFFFF ). Status codes: s suppressed, d damped, h history, * valid, > best, i - internal, r RIB-failure,ccnp switch workbook, S Stale Use set as-path tag to restore, for example, this example on R3 , Default-router 192.168.10.254 [123].[7-9] Fa0/20 Route-map test permit 10 The router goes to update the route of 3.0.0.0 Of course, on R3 , the same effect can be achieved with the distribution list in the in direction. Assuming the environment is like this, R1 re-releases A route into OSPF , then R2 will learn this OE2 in its own OSPF process 1 . 2 : RIP-2 ; General BGP routers do not accept containing its own AS routing information number, but can neighbor routing sources neighbors allowas-in a few of my as numbers , to make an exception. Router ospf 1 Route . 1 : the AS_PATH : 100 the MED : 200 is External RouterID : 1.1.1.1 Using this feature may reduce the performance of the device to a certain extent. In addition, you must ensure that CDP is enabled for both the neighbor and the router interface . Process switching and CEF support this feature, but dCEF does not. Route-map PBR permit 20 match ip address 2 Initially, R3 can learn three loopback routes from R1 and 192.168.12.0/24 routes. Now we don't want R3 to learn the route to 192.168.3.0/24 , then we can configure it on R2 as follows: Another problem with proxy ARP (from TCP/IP routing technology volume one) Basic experiment RA(as200) RB(as100) RC(as100) Next, look at RP , SW2 has two interfaces, both of which will receive BPDUs , all from SW1 , so the cost of the first two BPDUs to root is 0 , equal; the sender ID of the sender is due to the same switch, and therefore equal, less out; and then compare the two BPDU port ID , that is, SW1 on both port interface ID , we assume that the two interfaces equal priority, then the ratio of these two ports The interface ID , and finally select the root port F0/1 on SW2 .