ccnp switch timers

ccnp switch timers

If there are multiple routes from the same neighboring AS and multiple paths are available through Maximum-paths , all routes with the same cost are added to Loc-RIB. Access-list 1 permit 172.16.1.0 route-map unsupp permit 10 match ip address 11 Match metric matches the route with the specified metric. match route-type matches the specified type of route match community matches the BGP community. We restore the experimental environment to the basic configuration: BGP neighbor relationships are as follows Match ip address 1 set metric 10 3.3.3.3 The Fa0/0 interface is divided into two sub-interfaces, and the encapsulation protocol Dot1Q is configured . At the same time, the traffic is tagged with VLANs , so that a trunk is started between the switch and the router . The two sub-router interfaces are arranged two VLAN gateways in the IP , as VLAN user gateway. We know that the AD value of a static route is 1. The above configuration method actually changes the AD value of the static route to 10 . In this way, we have two default routes, one for the telecom exit, the AD value is the default 1 ; the other points to the education network exit, and the AD value is 10 . Then after Type ( Type ) (for forwarding delay), this TC will last for 35s ( 20+15 ) Routing Protocols Port-Security Router bgp 300 100 * i100.0.2.0/24 Vlan 10 Activates self-recovery of the err-disable interface due to arp-inspection violations . After the policy to take effect View R4 's BGP table: The election of the Root Bridge will not be said. Next turn on DAI on SW1 : Because Layer 3 switches support so many types of interfaces, the deployment of Layer 3 switching networks is more flexible and scalable. Interface f0/2 BGP neighbor relationship, the addresses are 3.3.3.3 , 4.4.4.4 , and 5.5.5.5 . The OSPF protocol runs in the AS , so that all routers can obtain the LOOPBACK network segment of other routers . On the R3 , BGP routes are advertised on the network segment 30.0 . R4 is the RR and R3 is the RR client . R5 will receive routing updates from 30 segments at the same time from R3 and R4 . How will it be routed? Which routing rule takes effect? First rule 8 does not apply because the two BGP routes NEXT_HOP are equal,ccnp switch timers, both are 3.3.3.3 , not comparable (reaching 3.3.3.