ccnp switch official certification guide pdf 300-115

ccnp switch official certification guide pdf 300-115

SW1(config-if)# glbp 1 10.1.1.254 If there is a tag , compare the VLAN tag of the frame with the PVID of the port . If the two are consistent, proceed to the next step; otherwise, discard the frame. The process of processing a VLAN frame by a trunk port is as follows: If the interface is configured as a hybrid interface 10.1.13.1 Path Router bgp 100 Both R1 and R2 inject 100.0.1.0 and 100.0.2.0 into BGP using network . In the cmd of windows PC , the packet size after ping is the size of ICMP data , ping –l 1472 , and the generated packet is 1500 bytes. By default, no rate limit is configured. The secure address learned dynamically through voice vlan will not be converted to sticky mac address. None Note: If CDP- based detection and object tracking- based detection are applied, the latter is preferred. Create secure addresses through dynamic learning, manual configuration, and stciky NEXT_HOP on NMBA network We can use the ip route-cache command , is enabled on the interface fast switching show ip cache to check the fast switching -related information . 3.3.3.3 Planning Principles R2 At this time we look at the state of the trunk on SW1 : RIP-1 Only Disable port Next hop What are the components of CEF : Let's take a look at R4 : From this experimental analysis, the automatic aggregation of BGP is obtained ,ccnp switch official certification guide pdf 300-115, and the main class network boundary is not required, which is different from the IGP . *> 100.0.1.0/24 5.5.5.5 Configuration command Forward Delay time listening to the learning state, or learning state to forwarding state required time defaults to 15s . In order to let R4 know that R5 is its federated EBGP neighbor, instead of a normal EBGP neighbor, you need to add the following configuration: FastEthernet FastEthernet IEEE 802.3 Switchport The Spanning-tree portfast feature cannot be configured directly on the trunk mode interface, otherwise the CISCO IOS will not take effect even if it is configured , unless the interface becomes access mode. If you really need to configure on the trunk interface, for example, if the interface is connected to a server that supports trunks , then add the trunk keyword to the Spanning-tree portfast command .